Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Multitel Manuals
  4. Controller
  5. FCCP BOX
  6. User manual

Multitel FCCP BOX User Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
User Manual
©

Advertisement

loading
Need help?

Need help?

Do you have a question about the FCCP BOX and is the answer not in the manual?

Questions and answers

Summary of Contents for Multitel FCCP BOX

  • Page 1 User Manual ©...
  • Page 3 ©...
  • Page 4 Open Circuit Alarm Relay Behavior ________________________________________________________ 17 FCCP Relay Output Behavior (ALM1 and ALM2) ______________________________________________ 17 OPERATION VERIFICATION __________________________________________________________ 18 CONTACTING MULTITEL ____________________________________________________________ 18 Addendum A – Terminal Block Description _____________________________________________ 19 Addendum B – FCCP Box 4.20mA with Display Option ____________________________________ 20 ©...
  • Page 5 ©...
  • Page 6 ©...
  • Page 7 ©...
  • Page 8 ©...
  • Page 9 • • • • • • • • • • • • • ©...
  • Page 10 • • 1416 1 2 3 1 2 3 14 16 ©...
  • Page 11 ©...
  • Page 12 Locate the negative battery cable(s) around which the current transducer will be installed. 1. Open the current transducer by twisting the pin and pulling without removing it from the transducer 2. Pull the yellow or white keyed plastic pin until it stops (about one inch or 2.5 cm). 3.
  • Page 13 Calibrating the FCCP       FCCP Calibration Note : ➢ ©...
  • Page 14 5. Wiring Alarm Signal ©...
  • Page 15     FLOAT CHARGING CURRENT PROBE PRESS SI M ULTENOUSLY FOR LAMP TEST PROBE DIAM. MAX. (0.080" / 2mm) CALIBRATION TEST POINTS MODE 50 mV MULTIMETER VD C RANGE VA C LOW IM PED AN CE AUTOM ATIC CAT III SELECTION 600 V...

  • Page 16: Mode Button

    MODE BUTTON LED BEHAVIOUR PARAMETERS TIMER CURRENT ENSOR STATUS OUT OF RANGE ENSORS ALARM TEMP ALARM Open-Circuit threshold Press 1X sensor A Thermal Runaway/High Press 2X threshold sensor A Open-Circuit threshold Press 3X sensor B (if applicable) Return to NORMAL MODE Press 8X •...
  • Page 17 • • • • • • • ©...
  • Page 18 • • • • ©...
  • Page 19 Terminal Name Description Contact Capacity +Vin +125V (67.2 - 154 Vdc) Power Input -Vin 0V (Battery return) Chassis ground Display Input Signal (+) 0V - 154Vdc Analog Input Display Com Input Signal (-) Display Output Alarm (COM) Dry Contact to send alarm to remote Display Alarm Relay monitoring unit (Switching voltage Display Output Alarm (NO)
  • Page 20 ©...
  • Page 21 ©...
  • Page 22 ©...
  • Page 23 ©...
  • Page 24 ©...