Power-Pole MOVE MV-AC-INFO-DISPLAY Instructions

WIRELESS INFO DISPLAY INSTRUCTIONS
TOOLS
• Fine-tip Marker
• Electric Drill
• 7/32" Drill Bit
• 7/64" Drill Bit
• #2 Phillips-Head Bit
A
G
DRILL MOUNTING HOLES
STEP 1 Choose a flat surface with adequate space to mount the Info Display.
STEP 2 Lay the mounting template in the desired mounting location and drill pilot holes for
Mounting Screws C
IMPORTANT! If installing to gel-coat, follow the drilling procedure in Appendix A of the
Installation and Owner's Guide to ensure you do not crack or chip the gel-coat.
PREFERRED INSTALLATION (Installing Wire Through Boat)
STEP 1 Using a #2 Phillips Head Screwdriver, install (2) Screws
STEP 2 Drill routing hole for wire with a 7/32" Drill Bit.
Need help? Contact our Technical Support Team at 1 + 813.689.9932 Option 2
INCLUDED HARDWARE
QTY. LABEL ITEM #
1 A SA-0046
2 B AVG-MP-0608
2 C AVG-MH-SC-0298
2 D AVG-MP-1013
2 E AVG-MP-1014
1 F AVG-MP-1002
1 G AVG-MP-0935
1 H magnet-bot-PP
B
C
2"
D
3 3/4"
E
F
using a 7/64" drill bit.
DESCRIPTION
Info Display
Info Display Base
#8 x 1/2" Phillips Head Screw
Heat Shrink Ring Terminal, 18-22 AWG, 3/8"
Heat Shrink Ring Terminal, 18-22 AWG #10
Heat Shrink Butt Connector, 18-22 AWG
Fuse Holder, ATC, and ATO 18 AWG Red Lead
Pairing Magnet
Dimensions Cord Length Wire Gauge
2" x 3 3/4"
H
and tighten until flush.
C
Fuse Size
~4 ft. 20 AWG 2 Amp Mini
Check the area beneath where the
Display will be mounted to ensure there
are no hoses, wires, lines, tanks, or other
sensitive components.
Mounting Holes
C
Hole for Wire
C