Installation - Pioneer Premier FH-P800BT Installation Manual

Installation

English
Installation using the screw
Note
holes on the side of the unit
• Check all connections and systems before final
installation.
Fastening the unit to the factory
• Do not use unauthorized parts. The use of
radio-mounting bracket.
unauthorized parts may cause malfunctions.
• Consult with your dealer if installation requires Position the unit so that its screw holes are
aligned with the screw holes of the bracket,
drilling of holes or other modifications of the
vehicle. and tighten the screws at 3 or 4 locations on
• Do not install this unit where: each side.
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
• Do not install the display where it may (i) obstruct
the driver's vision, (ii) impair the performance of
any of the vehicle's operating systems or safety
features, including air bags, hazard lamp buttons
or (iii) impair the driver's ability to safely operate
the vehicle.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
• Optimum performance is obtained when the unit
is installed at an angle of less than 60°.
If the pawl gets in the way,
bend it down.
Factory radio
mounting bracket
• To some types of vehicles, this unit cannot be
properly installed. In such case, use the optional
installation kit (ADT-VA133).
• When installing, to ensure proper heat dispersal
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.
Leave ample space Dashboard
Binding screw or
5cm flush surface screw
Be sure to use the
screws supplied
with this unit. Dashboard or console
10cm
Note
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If this
happens, use the supplied frame to fill the gap.
Installation English
Installing the microphone 2. Install the microphone clip on the
sun visor.
Installation notes
With the sun visor up, install the microphone
clip. (Lowering the sun visor reduces the rec-
Install the microphone in a position and
ognition rate for voice operations.)
orientation that will enable it to pick up the
voice of the person operating the system. Microphone clip
CAUTION
It is extremely dangerous to allow the mi-
crophone lead to become wound around
the steering column or gearstick. Be sure to
install the unit in such a way that it will not
obstruct driving.
When installing the microphone
on the sun visor
1. Install the microphone on the Clamps
Use clamps to secure
microphone clip.
the lead where necessary
inside the vehicle.
Microphone
When installing the microphone
on the steering column
Microphone clip
1. Install the microphone on the
microphone clip.
Microphone
Fit the microphone
Microphone clip lead into the groove.
Installation English
2. Install the microphone clip on the
steering column.
Double-sided tape
Install the microphone clip on the
rear side of the steering column.
Clamps
Use clamps to
secure the lead
where necessary
inside the vehicle.
Adjusting the microphone
angle
The microphone angle can be adjusted by
moving forward or backward the microphone
clip angle.