Advertisement

Hino N04C
Workshop Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the N04C and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hino N04C

  • Page 1 Hino N04C Workshop Manual...
  • Page 2: Section Index

    SECTION INDEX NAME SECTION GENERAL TROUBLESHOOTING ENGINE OVERHAUL FUEL SYSTEM COOLING SYSTEM LUBRICATION SYSTEM STARTING SYSTEM CHARGING SYSTEM TURBOCHARGER SYSTEM APPENDIX Find manuals at https://best-manuals.com...
  • Page 3 Find manuals at https://best-manuals.com...
  • Page 4: Table Of Contents

    GENERAL Page SPECIFICATIONS ..........0-2 ENGINE EXTERIOR VIEWS ........0-3 ENGINE PERFORMANCE CURVES .....0-4 HOW TO USE THIS MANUAL .......0-5 .........0-5 EXPLANATION METHOD ............0-6 TERMINOLOGY ............0-7 ABBREVIATIONS OPERATING TIPS ..........0-8 POINTS FOR WHICH SPECIAL CARE ...........0-8 MUST BE TAKEN ........0-8 GENERAL INSTRUCTIONS ......
  • Page 5 Find manuals at https://best-manuals.com...
  • Page 6: Engine Exterior Views

    ENGINE EXTERIOR VIEWS Find manuals at https://best-manuals.com...
  • Page 7 Find manuals at https://best-manuals.com...
  • Page 8 Find manuals at https://best-manuals.com...
  • Page 9 Find manuals at https://best-manuals.com...
  • Page 10: Abbreviations

    ABBREVIATIONS Reference symbol Original word Meaning Right Hand Right hand side Left Hand Left hand side Front Front Rear Rear This refers to the part size used by the maker at the time of assembly Standard being the standard size. For parts that do not engage well anymore due to wear from long use, or repeated disassembly, by replacing the part that is engaged by a part Over Size...
  • Page 12 Prevention of damage to parts Damage to contact surfaces or rotating parts can cause oil leakage or burning. (1) To disassemble contact surfaces of parts, do not use a screw driver or such, but tap them lightly with a plastic hammer to separate them. (2) When clamping parts in a vice, do not clamp them directly in the vice, but between aluminum plates.
  • Page 14: Electrical Parts Inspection

    0-11 ELECTRICAL PARTS INSPECTION Always disconnect the battery plug before inspecting or servicing electrical parts. Pay sufficient attention when handling electronic parts. (1) Never subject electronic parts, such as computers and relays, to impact. (2) Never expose electronic parts to high temperature or humidity.
  • Page 16: Bolt & Nut Tightening Torques

    0-13 BOLT & NUT TIGHTENING TORQUES Standard Bolt & Nut Tightening Torque Tightening torques of standard bolts and nuts are not indicated throughout the manual. Use the procedures and table below to judge the standard tightening torque. Judge the tightening torque for the hexagon head bolt, welded bolt or stud bolt having the standard bearing surface according to the tightening torque table by identifying the bolt strength class from the table below.
  • Page 21 This as a preview PDF file from best-manuals.com Download full PDF manual at best-manuals.com...

Table of Contents

Save PDF