Advertisement
Available languages
Available languages
Installation
ENGLISH
2. Install the microphone clip on the
Adjusting the microphone angle
steering column.
The microphone angle can be adjusted by
moving forward or backward the micro-
Double-sided tape
phone clip angle.
Install the microphone clip on the rear side
of the steering column.
Clamps
Use clamps to
secure the lead
where necessary
inside the vehicle.
Connecting the Units
ENGLISH
Note:
•
Control signal is output through blue/white cable
when this unit is powered on. Connect it to an
•
When this unit is installed in a vehicle without
ACC (accessory) position on the ignition switch,
external power amp's system remote control or
red cable must be wired to the terminal that can
the vehicle's auto-antenna relay control terminal
detect the operation of the ignition key.
(max. 300 mA, 12 V DC). If the vehicle is
equipped with a glass antenna, connect it to the
Otherwise, battery drain may result.
antenna booster power supply terminal.
•
Never connect blue/white cable to external power
amp's power terminal. Also, never connect it to
the power terminal of the auto antenna.
Otherwise, battery drain or malfunction may
result.
•
IP-BUS connectors are color-coded. Be sure to
connect connectors of the same color.
•
Black cable is ground. This cable and other prod-
ACC position
No ACC position
uct's ground cable (especially, high-current prod-
•
Use this unit in other than the following condi-
ucts such as power amp) must be wired separate-
tions could result in fire or malfunction.
ly. Otherwise, fire or malfunction may result if
— Vehicles with a 12-volt battery and negative
they are accidentally detached.
grounding.
•
Cord function may differ according to the
— Speakers with 50 W (output value) and 4 ohm
product, even if cord color is the same. When
to 8 ohm (impedance value).
connecting this system, be sure to check all
•
To prevent short-circuit, overheating or malfunc-
manuals and connect cords correctly.
tion, be sure to follow the directions below.
— Disconnect the negative terminal of the battery
before installation.
— Secure the wiring with cable clamps or adhe-
sive tape. To protect the wiring, wrap adhesive
tape around them where they lie against metal
parts.
— Place all cables away from moving parts, such
as gear shift and seat rails.
— Place all cables away from hot places, such as
near the heater outlet.
— Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery.
— Cover any disconnected cable connectors with
insulating tape.
— Do not remove RCA caps if RCA cables are
not used.
— Do not shorten any cables.
— Never cut the insulation of the power cable of
this unit in order to share the power to other
equipment. Current capacity of the cable is
limited.
— Use a fuse of the rating prescribed.
— Never wire the speaker negative cable directly
to ground.
— Never band together multiple speaker's nega-
tive cables.
Hide quick links:
Advertisement
