Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Gazelle GH3070
Summary of Contents for Gazelle GH3070
- Page 1 GH3070 Demolition Hammer User Manual...
- Page 2 Original Instructions Before using this Gazelle demolition hammer, please carefully read though these HANDLING INSTRUCTIONS. Ensure that you know how the machine works, and how it should be operated. Maintain the machine in accordance with the instructions, and make certain that the machine work correctly, please store this instriation and other enclosed documents with the machine together.
- Page 3 The tool is to be used only for its prescribed purpose. Any other use is deemed to be a case of misuse. Contents Machine information Assembly Safety instruction Operation Maintenance Warranty Environment Machine information Technical specifications Machine Type GH3070 Voltage AC 220-240V 110-120 V Frequency 50/60Hz Input power 2000W Impact rate 1000/min Weight 29.36kg Impact energy Wear hearing protection while operating the power tool.
-
Page 4: Standard Accessories
The declared vibration total value(s) and the declared noise emission value(s) have been measured in accordance with a standard test method and may be used for comparing one toolwith another; The declared vibration total value(s) and the declared noise emission value(s) may also be used in a preliminary assessment of exposure. -
Page 5: Safety Instructions
Safety instructions In this operator's manual/or machine’s labels following symbols are used: Denote risk of personal injury, loss of Read the operating lifeor damage to the toolincase of instructions before use. nonobservance of the instruction in this manual. Accordance with essential applicable Indicate electrical shock hazard. - Page 6 d. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock. e. When operating a power tool outdoors, use an extension cord suitable for outdoor use.
- Page 7 e. Maintain power tools and accessories. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
- Page 8 17. Special attention to voltage: Before connect the power tool, please make sure the rated voltage on the tool can match the power supply, otherwise the power tool may be damaged and cause injuries. 18. Don't wipe plastic part with solvent: Solvent such as gasoline, thinner, alcohol etc. these kind of chemical material, are not allowed to use, water or soap are recommended! 19.
- Page 9 Switch operating Observe correct mains voltage! The voltage of the power source must agree with the voltage specified on the type plate of the power tool. Press the switch towards ①direction Switch on Release the switch towards ②direction Switch off For low temperatures, the power tool reaches the full impact rate only after a certain time.
-
Page 10: Maintenance And Inspection
The assembly if bit with shoulder ( see Fig 3 & Fig 4) The shank length should be 160mm(6 10/33 inch) (Length from shank end to the shoulder) Operate the lock part 2 to 210 Degree position, insert the bit 1 into the holder 3. Operate the lock part 2 to180 degree position, can lock the bit. - Page 11 sales@gazelleindustrial.com | www.gazelleindustrial.com...
Need help?
Do you have a question about the GH3070 and is the answer not in the manual?
Questions and answers