Do you have a question about the White Rogers ACM1000M Series and is the answer not in the manual?
Questions and answers
Summary of Contents for Copeland White Rogers ACM1000M Series
Page 1
Model Number ACM1000M-XXX ACM1400M-XXX ACM1600M-XXX ACM2000M-XXX OWNERS MANUAL • Installation • Operation • Maintenance Please read and familiarize yourself with the contents of this manual before installing, operating or performing maintenance on the unit. PART NO. 37-7001002 Replaces 37-7001001 www.copeland.com/white-rodgers 2048...
INTRODUCTION The White-Rodgers Media Air Cleaner comes complete GUARANTEE with a 4” media furnace air filter. This filter must be White-Rodgers will not assume any responsibility for changed every three to six months to maintain efficiency component failures due to incorrect installation procedures. of the filter and furnace system.
HOW THE AIR FILTER WORKS Dirty air fows through your return air ducts and enters the compartment where particles (hair, lint, etc.) are removed by 4" FILTER the flter. See fgure 1. Filtered air re-enters to the supply duct system of your building. DIRTY AIR IN FILTERED AIR OUT Figure 1...
PRE-INSTALLATION LOCATING THE AIR FILTER 3. The air flter is not to be placed in the discharge of either the heating or cooling unit. Your air flter must be mounted in the return air duct of a central 4. IMPORTANT: If atomizing spray type humidifer is used, it forced-air system, on the air entering side of your furnace.
TYPICAL MOUNTING POSITIONS AIR FLOW AIR FLOW Figure 5 Figure 6 BASEMENT FURNACE (LOWBOY) COUNTERFLOW FURNACE Filter is mounted horizontally in return plenum, just above Filter is mounted horizontally furnace. in return duct or plenum, just above furnace. AIR FLOW Figure 7 Figure 8 HIGHBOY FURNACE...
INSTALLATION REMOVE OLD FILTER AND DISCARD (Figure 11) NOTE: This flter may be mounted in the furnace compartment. CLEAN BLOWER COMPARTMENT NOTE: The air flter cannot remove dirt from blower and ducts. Figure 11 INSTALLATION The following is a typical installation of the air flter on a “Highboy”...
Need help?
Do you have a question about the White Rogers ACM1000M Series and is the answer not in the manual?
Questions and answers