Solight PO80 Manual

EN PO80, PO80B
Surge protector with extension cord
and USB charger
Thank you for purchasing our product. Please read this manual carefully and heed the safety warnings and instructions before installing,
using or repairing the equipment. This will ensure not only the protection of persons, but also the long life of the equipment.
Surge protection prevents the risk of damage, malfunction or malfunction of electrical, electronic, telecommunications and similar equipment.
Storms and surges, the connection of renewable energy sources or the maintenance of transmission systems create constant fluctuations
in the parameters of the power grid.
1. Product description
2. Use and description of functions
a) Completely unwind the power cord and plug into an electrical outlet. Then plug the appliances into the surge protection sockets.
Connect the USB cables. Press the main power switch, all LED indicators will light up with green light. When disconnecting, follow
the opposite procedure.
b) During a mains overload event, the surge protector varistor will absorb a dangerous overvoltage and burn out. It will no longer be
functional. The surge protector LED indicator will go out. The unit can still be used as an extension lead without surge protection.
c) The electrical outlets are protected against overcurrent by the connected appliances by a thermal fuse. If the total load exceeds
16A or the load capacity limits of the electrical circuit are reached, overheating will occur and the thermal fuse will cut off power to
the electrical outlets and the USB charger. Disconnect the main power cord from the power outlet. Disconnect critical equipment
that is causing the overload or remove the mains condition(s) triggering the protection. Allow approximately 5 to 10 minutes for the
product to cool down. Then briefly press the circuit breaker reset button. Plug the main power cord back into the wall outlet. Press
the main switch to turn on the power supply. The product is ready for operation again.
d) The USB charger is protected against overcurrent, overheating and short circuit. When the protection is activated, the power supply
to the USB ports is interrupted. Disconnect the main power cord from the power outlet. Disconnect the critical device that is causing
the overload or remove the network condition(s) triggering the protection. Plug the main power cord back into the power outlet.
Press the main power switch to turn on the power. USB power will be restored.
e) The retractable holder on the back of the surge protector is used for hanging or carrying. Mounting holes on the back are used for
permanent attachment to the surface.
3. Safety notices
Operating environment: The product is intended for indoor use only. Do not use it outdoors. Do not cover. Do not immerse in water. Do not
expose the product to mechanical stress, extreme temperatures, strong shocks, flammable gases, aggressive chemical environments.
Protect from high humidity and direct sunlight.
Do not connect the product to an outlet in series with other extension cords, splitters or other surge protectors. Handle power cords only
when disconnected from the mains. If liquid enters the product, immediately disconnect the power from the outlet where the extension cord
is plugged in (switch off the fuse/fuse/residual current controlled circuit/associated circuit breaker). Only then pull the plug of the main power
cord from the mains socket. If in doubt about operation, safety or wiring, consult a specialist. If the product can no longer be used safely,
remove it from service and take it to a separate waste collection point. Do not dispose of in normal household waste.
Keep away from children. Children cannot recognize the dangers of improper use of electrical equipment. They can endanger life and cause
electric shock! Use for purposes other than those described may result in damage to the product. Improper use may cause short circuit, fire,
electric shock or other hazards. Do not tamper with wiring, do not exceed the permitted load, clean disconnected from the mains. Do not
use aggressive cleaning agents, alcohol or other chemical solutions when cleaning. Wipe the product with a dry cloth, allow to dry thoroughly.
Solight Holding s.r.o. is in no way liable for property damage or personal injury caused by improper installation or incorrect use.
The product complies with legal national and European requirements and has been issued with a CE Declaration of Conformity.
1 - Main switch, controls power sockets and USB charger
2 - Surge Protected Active LED indicator - green (Surge Protected)
3 - LED indicator Plugged in and protective wire Active - green (Power ON)
4 - USB port protection Active - green (USB A+C Protected)
5 - Resettable circuit breaker to protect against overload by connected appliances
Solight Holding, s.r.o., Na Brně 1972, Hradec Králové 500 06, Česká republika.