Download Print this page

Waterworld CT-1 Installation & Service Manual

Counter top drinking water system

Advertisement

Quick Links

Counter Top
Drinking Water System
CT-1
Single Stage
Model CT-1 consists of 1 replacement filter.
Filter Part # ________________________
Installation &
Service Manual
Double Stage
Model CT-2 consists of 2 replacement filter.
Filter Part 1 # ______________________
Filter Part 2# _______________________
CT-2
Model CT-3 consists of 3 replacement filter.
Filter Part 1 # ______________________
Filter Part 2# _______________________
Filter Part 3 # ______________________
CT-3
Triple Stage

Advertisement

loading
Need help?

Need help?

Do you have a question about the CT-1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Waterworld CT-1

  • Page 1 ❑ ❑ Single Stage Double Stage Triple Stage Model CT-1 consists of 1 replacement filter. Model CT-2 consists of 2 replacement filter. Model CT-3 consists of 3 replacement filter. Filter Part # ________________________ Filter Part 1 # ______________________ Filter Part 1 # ______________________...
  • Page 2 Installation Start by removing the aerator from your faucet. (See Figure A.) Usually you can take it off with your fingers. If needed, use pliers. It’s a normal “right hand” thread. Remove by turning counter-clockwise. Save the aerator. If you move your filter later, you’ll need it. 2) Next, simply screw the diverter valve on in place of the aerator.
  • Page 3 CT SYSTEM LIMITED WARRANTY ® Congratulations on the purchase of your WW-USA Water System. WW-USA warrants that the Products identified below are free from material defects in materials and workmanship. Any defective part will be replaced at no charge for the part if any fail- ure caused by the defect occurs within the following time periods originating from the date of original system installation.
  • Page 4 Counter Top Drinking Water System Filter Cartridge Changing: 1) Open the canister(s) and discard the old filter(s). 2) Clean the inside of the filter housing with a mild soap and water solution. A mild bleach solution may also be used for disinfection. Rinse well. 3) Remove o-ring(s) and apply a very small amount of FDA approved silicone o-ring lubricant.

This manual is also suitable for:

Ct-2Ct-3