Advanced Tasks; Managing Protecttools Settings; Enabling And Disabling Java Card Power-On Authentication Support; Enabling And Disabling Power-On Authentication Support For Embedded Security - HP dc5700 - Microtower PC Manual

Advanced Tasks

Managing ProtectTools Settings

Some of the features of ProtectTools Security Manager can be managed in BIOS Configuration.

Enabling and Disabling Java Card Power-On Authentication Support

If this option is available, enabling it allows you to use the Java Card for user authentication when you
turn on the computer.
NOTE
Card using the Java Card Security for ProtectTools module.
To enable Java Card Power-On Authentication support:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, select BIOS Configuration.
3. Enter your Computer Setup administrator password at the BIOS administrator password prompt,
and then click OK.
4. In the left pane, select Security.
5. Under Java Card Security, select Enable.
NOTE
6. Click Apply, and then click OK in the ProtectTools window to save your changes.

Enabling and Disabling Power-On Authentication Support for Embedded Security

If this option is available, enabling it allows the system to use the TPM embedded security chip for user
authentication when you turn on the computer.
NOTE
embedded security chip using the Embedded Security for ProtectTools module.
To enable Power-On Authentication support for embedded security:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, select BIOS Configuration.
3. Enter your Computer Setup administrator password at the BIOS administrator password prompt,
and then click OK.
4. In the left pane, select Security.
5. Under Embedded Security, select Enable Power-On Authentication Support.
NOTE
6. Click Apply, and then click OK in the ProtectTools window to save your changes.
6 Chapter 1 Introduction
To fully enable the Power-On Authentication feature, you must also configure the Java
To disable Java Card Power-On Authentication, select Disable.
To fully enable the Power-On Authentication feature, you must also configure the TPM
To disable Power-On Authentication for Embedded Security, select Disable.
ENWW