Advertisement
Quick Links
SUPPLIED MATERIAL
Input plate
analog outputs
Plastic
washer
BOX FORMAT ASSEMBLY
1
Disconnect power from the
Agrónic 4500.
Position the analog input/
4
output plate on top of the spacers
and secure it with the three screws
and plastic washers.
Analog I/O plate
Screws for fastening
Agrónic 4500
Installation of analog inputs and
outputs in box format
RJ11 and RJ45
cables
Screw
Spacer
M3x6
15 mm
2
Remove the four screws.
5
When installing two analog I/O plates, it is important to pay attention to the
jumper configuration. The position determines whether the plate is identified as
number 1 or number 2.
1
st
expansion
2nd Expansion
Material
1 Expansion
Analog I/O plates
Connection terminal
M3x6 screws
Plastic washer
15 mm spacer
RJ11 Cable
RJ45 Cable
3
Material supplied in:
2 Expansions
1
2
1
2
3
3
3
3
-
3
1
2
1
2
Lift the keyboard.
Manual - Agrónic 4500 ·
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Progress Agronic 4500
Summary of Contents for Progress Agronic 4500
- Page 1 Agrónic 4500 Installation of analog inputs and outputs in box format SUPPLIED MATERIAL Material supplied in: Material 1 Expansion 2 Expansions Analog I/O plates Connection terminal M3x6 screws Plastic washer RJ11 and RJ45 Input plate 15 mm spacer cables analog outputs RJ11 Cable RJ45 Cable Plastic...
- Page 2 Make the connection between To install a second analog input/output plate, replace the three existing the plates with the supplied cables screws with the three supplied spacers. as indicated in the image. M3 x 6 screw and Plastic washer expansion 15 mm spacer expansion Close the unit and replace...
- Page 3 Agrónic 4500 Installation of analog inputs and outputs in built-in format SUPPLIED MATERIAL Material supplied in: Material 1 Expansion 2 Expansions Analog I/O plates Connection terminal M3x6 screws Plastic washer RJ11 and RJ45 Analog input 15 mm spacer cables output plate RJ11 Cable RJ45 Cable Plastic...
- Page 4 Depending on the number of Place and secure the plate or plates provided using the screws and washers panels to install, connect the cables as shown in the following image. (RJ11 and RJ45) between the different panels. expansion M3 x 6 screw and expansion Plastic washer Relay plate...
Need help?
Do you have a question about the Agronic 4500 and is the answer not in the manual?
Questions and answers