Table of Contents
Advertisement
Quick Links
Pressure Washer
User Manual
Model No.: YLQ4505H-130C
Rev 1
READ AND SAVE THESE INSTRUCTIONS
Note: This appliance's specifications and/or components are subject to change without prior notice.
If any Accessories should fail during use, please call 1300 105 888 (Australia) or 09 8870 447 (New Zealand) for
an immediate replacement. This will save you from returning the product to the store.
If we can assist you in any other way, please feel free to contact us.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for anko YLQ4505H-130C
- Page 1 Pressure Washer User Manual Model No.: YLQ4505H-130C Rev 1 READ AND SAVE THESE INSTRUCTIONS Note: This appliance's specifications and/or components are subject to change without prior notice. If any Accessories should fail during use, please call 1300 105 888 (Australia) or 09 8870 447 (New Zealand) for an immediate replacement.
- Page 2 Page 2 of 28...
-
Page 3: Table Of Contents
Warnings ................4 Product Characteristics ............9 Specification ................. 9 Components ............... 10 Assembly ................11 Wheels ................. 11 Spray Gun Holster .............. 11 Power Cord Hook ............... 12 Wand Extension Holder ............. 12 Handle ................. 13 Water Inlet / Filter Connector ..........13 Pressure Hose .............. -
Page 4: Warnings
Warnings Before using this appliance, read and follow all warnings and instructions in this manual, even if you are familiar with this product. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. - Page 5 Check important components, such as the high-pressure hose, hand spray gun for damage prior to every operation. Immediately replace damaged components. Do not operate the appliance with damaged components. High-pressure water jets can be dangerous if subject to misuse. Do not direct the water jet against yourself or others to clean clothes, footwear, etc.
- Page 6 If this appliance is to be used by a third party, please supply the instruction manual with it. The water jet that is emitted from the high-pressure nozzle results in a repulsion power acting on the hand spray gun. Make sure that you have a firm footing and are also holding the hand spray gun and spray lance firmly.
- Page 7 Position the power supply cord properly so that it will not be walked on or pinched by items placed on or against it. Use only clean water. Mind the weight of the appliance when selecting the storage location and during transport to prevent accidents or injuries.
- Page 8 During the use of high-pressure cleaning, aerosols can develop. Inhaling aerosols can be harmful to your health. DO NOT store or use the appliance near or in high-temperature areas. DO NOT use the appliance if the power cord is damaged. Do not repair by yourself.
-
Page 9: Product Characteristics
Product Characteristics The intended use of this product covers the cleaning of vehicles, buildings, terraces, facades, and garden equipment using clean water and detergents. Likewise, the product can be used to clean paving slabs or rain gutters. This product must not be used to clean clothing, shoes, and other textiles. For safety reasons it is essential to read the entire instruction manual before first operation and to observe all the instructions there in. -
Page 10: Components
Components Item Description Item Description On / Off Switch Handle Holster Main Unit Water Inlet Connector / Filter High Pressure Hose Variable Spray Nozzle Wand Holder Trigger Safety Lock Power Cord Hook Wand Extension Screws Spray Gun Nozzle Cleaner Wheels Detergent Sprayer Carry Handle Page 10 of 28... -
Page 11: Assembly
Assembly Wheels To save on the amount of packaging waste, the appliance has been packed in the smallest box possible, however, this means a small amount of assembly is required before use. The only tool you will need is a Philips Head Screwdriver. After removing the appliance and components from the box, the first items to assemble are the Wheels. -
Page 12: Power Cord Hook
Power Cord Hook Take the Power Cord Hook and align with the slots on the side of the main unit, slide it on, then push all the way down hard until it locks in place. Wand Extension Holder Take the Wand Extension Holder and align with the slots on the top back of the main unit, slide it on, then push all the way down hard until it locks in place. -
Page 13: Handle
Handle Stand the main unit up, take the handle, then starting at the front of the appliance, slide the bottom of the handle into the mating slots in the top of the appliance and slide on all the way. Take the two screws and screw in firmly to secure the handle to the appliance body. -
Page 14: Pressure Hose
Pressure Hose Take the end of the Pressure Hose and screw (clockwise) onto the threaded spigot on the base of the main unit. Note: Remove the protection cap and discard first. Pressure Gun Take the other end of the Pressure Hose and push it into the hole located in the bottom of the handle. -
Page 15: Extension Wand To Pressure Gun
Extension Wand to Pressure Gun Take the Extension Wand and align the two large tabs at the spigot end with the two large slots in the coupling end of the Pressure Gun. Push the Gun onto the wand all the way down then whilst holding the Wand firmly, rotate the Gun clockwise to lock the Wand in place. -
Page 16: Detergent Sprayer
5.11 Detergent Sprayer The Detergent Sprayer is used for spraying your specific detergent, based on the job at hand, quickly and evenly over a large surface. The detergent in the bottle is automatically diluted with the water as it exits the spray Variable Spray Nozzle. -
Page 17: Trigger Lock
Trigger Lock The Spray Gun is fitted with a Locking Device to help prevent the trigger from being depressed accidently. To activate the lock, press the front of the rocker button in as shown below. To deactivate the lock, press the rear of the rocker button. Variable Spray Nozzle The Variable Spray Nozzle is adjustable to spray either a fine jet of water or a wide fan spray of water, or anything in between. -
Page 18: High Pressure Operation
Attach your garden hose into the water connection on the front of the • appliance and turn the Water On. DO NOT start the appliance yet. • Bleed the air from inside the hoses and main unit as follows prior to operation: If locked, unlock the Spray Gun Trigger. - Page 19 Squeeze the trigger on the gun and the pump will switch on and the high- • pressure water will be ejected from the end of the gun. WARNING! Beware of kickback when pressing the trigger. Let the device run (maximum of 2 minutes) to ensure everything is working •...
-
Page 20: Operation With Detergent
Operation with Detergent Detergent can only be added when the device is operated in low pressure mode. When the supplied Detergent Sprayer is attached to the end of the Spray Gun, this will automatically be in Low Pressure Mode. DANGER When using detergents, the material data safety sheet issued by the detergent manufacturer must be adhered to, including the instructions regarding personal protective equipment. -
Page 21: Storage
ATTENTION When disconnecting the water supply or the high-pressure hose, warm water may dribble out from the connection after operation. This is normal. Storage The main unit has provision for storing the Variable Spray Nozzle. Detergent • Sprayer, Power Cord, High Pressure Hose, and the Spray Gun. Variable Spray Nozzle and Detergent Sprayer Spray Gun and Extension Wand Page 21 of 28... -
Page 22: Cleaning Your Pressure Washer
High Pressure Hose and Power Cord Do Not wind the power cord around the appliance body as this will damage the cord over time. Simply loop the cable and place it on the hanging hook. Store the appliance safely and in a dry place. •... -
Page 23: Maintenance
11 Maintenance 11.1 Blocked Spray Nozzle Should you suddenly notice that the jet of water from the Variable Spray Nozzle or the Detergent Sprayer decreases significantly or stops all together, there could be dirt or a foreign object blocking the hole. This could happen from dirt or insects etc. -
Page 24: Blocked Inlet Water Filter
11.2 Blocked Inlet Water Filter Should you suddenly notice that the jet of water from the Variable Spray Nozzle or the Detergent Sprayer decreases significantly or stops all together, it could be a blockage in the water supply filter. The filter is located inside the Garden Hose connector which is screwed onto the front on the main unit. -
Page 25: Troubleshooting
12 Troubleshooting Switch On at power point. Power Not Switched On. Switch on Appliance Check to see if there is power No Power to Power Point supplied with another appliance, such as a lamp. Water Pump Will not Start. Squeeze the Trigger to allow Unit has already Pressurised water to flow which will restart the pump... - Page 26 Wait for pump/hoses or Pump/hoses or accessory frozen accessory to thaw. Connect inlet water and make sure water is coming out of the hose. No water supply Machine starts, but no Ensure water supply hose is not water comes out kinked or crushed Clean the filter /Clean the nozzle.
-
Page 27: Warranty Against Defect
13 Warranty Against Defect 12 Month Warranty Thank you for your purchase. Your new product is warrantied to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided. - Page 28 Page 28 of 28...
Need help?
Do you have a question about the YLQ4505H-130C and is the answer not in the manual?
Questions and answers