TM
OPERATOR'S MANUAL
A Division of Snow Joe, LLC
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Always follow these safety guidelines. Failure to do so may result
in serious bodily injury or death.
General Safety WARNINGS!
You and any other operator of this cordless claw tiller +
cultivator must read, understand, and follow these instructions
in their entirety. Failure to follow these instructions may result in
ELECTRIC SHOCK, FIRE, and/or serious PERSONAL INJURY.
Notice the personal safety alert symbol
manual to draw your attention to a WARNING given along
with the particular operating instruction. This means that
the operation requires special ATTENTION, CAUTION, and
AWARENESS.
1. Keep work area clean and well-lit – Cluttered, dark areas
invite accidents.
2. Replacement parts – When servicing this unit, use only
identical replacement parts. Replace or repair damaged
parts immediately.
3. Keep children, bystanders, and pets away –
All spectators, including pets, should be kept a safe distance
away from the work area.
4. Know your product – Know how to start and stop the
machine. Be thoroughly familiar with the controls.
5. Use the right tool – Do not use this machine for any job
except that for which it was intended.
6. Dress properly – Do not wear loose clothing or jewelry as
such articles can become caught in moving parts.
Wear a protective covering to contain long hair.
Wearing rubber gloves and substantial non-slip footwear is
recommended when working outdoors.
7. Avoid accidental starting – Do not carry the cordless claw
tiller + cultivator with your finger on the switch.
m
CAUTION!
Moving parts will continue to run for several
seconds after turning off the machine.
Original instructions.
© 2023 Snow Joe, LLC. All rights reserved.
R
CORDLESS CLAW TILLER + CULTIVATOR
24V* IONMAX | 2.0 Ah | 3.6-INCH
Model 24V-CTLR-LTE
m
used in this
8. Moving parts – Keep hands and feet away from moving
parts. Keep guards in place and in proper working order.
9. Do not force the tool – It will perform better with less
likelihood of personal or mechanical injury if it is used at the
rate for which it was designed.
10. Do not overreach – Keep proper footing and balance at all
times.
11. If the cordless claw tiller + cultivator strikes a foreign
object, follow these steps:
• Stop the cordless claw tiller + cultivator.
• Inspect for damage.
• Repair any damage before restarting and
operating the tool.
12. Use safety glasses – Also use safety footwear,
snug-fitting clothing, protective gloves, hearing, and head
protection.
13. Remove the battery – Remove the battery from the cordless
claw tiller + cultivator when it is not in use,
before servicing it, when changing accessories,
and when performing any other maintenance task.
14. Store idle tool indoors – When not in use, the cordless
claw tiller + cultivator should be stored indoors in a dry and
high or locked-up place out of the reach of children.
15. Maintain the cordless claw tiller + cultivator with
care – Keep the cutting edges sharp and clean for optimal
performance and to reduce the risk of injury.
Keep the handles dry, clean, and free from oil and grease.
Follow the additional recommendations described in the
maintenance section of this manual.
16. Avoid dangerous environments – Do not use the cordless
claw tiller + cultivator in rain or in damp or wet locations. Do
not operate the cordless claw tiller + cultivator in gaseous
or explosive atmospheres or use the cordless claw tiller +
cultivator near flammable or combustible liquids. Motors
in these tools normally spark, and the sparks might ignite
fumes.
17. Stay alert – Watch what you are doing. Use common sense.
Do not operate the cordless claw tiller + cultivator when you
are tired or under the influence of drugs, alcohol, or other
medication.
*DISCLAIMER: Initial no-load voltage, when fully charged,
peaks at 24V; nominal voltage under typical load is 21.6V.
1
Form No. SJ-24V-CTLR-LTE-880E-M-FTY
SAVE THESE INSTRUCTIONS
Need help?
Do you have a question about the SUNJOE 24V-CTLR-LTE and is the answer not in the manual?
Questions and answers