Subscribe to Our Youtube Channel
Summary of Contents for Nedap FLUX READER
- Page 1 Nedap Flux Gateway and Reader Installation Manual Public 528003 Version: December 2024...
-
Page 2: Table Of Contents
Flux Reader Flux Gateway Copyright-Disclaimer-Warranty Copyright Disclaimer Warranty and spare parts Installation and use Compliancy FLUX READER Technical information FLUX GATEWAY Technical information Flux Reader Installation Testing Operating Replacing batteries Flux Gateway Installation LED Indications for testing Operating Cleaning Problem solving... -
Page 3: Flux Reader
Copyright © Nedap N.V. All rights reserved. The information in this document is subject to change without notice, it is not to be reproduced in any way, in whole or in part, without the written consent of Nedap N.V. Nedap Flux is a registered trademark of Nedap N.V. -
Page 4: Warranty And Spare Parts
At the sole discretion of Nedap N.V., Nedap N.V. may decide to change the conditions of the warranty policy. You agree that Nedap N.V. is able to compensate you the pro-rata value of the warranty involved rather than replacing or repairing the product depending on the technical or economical value of the product. -
Page 5: Flux Gateway Technical Information
The FLUX READER communicates with the FLUX GATEWAY, so for operating and testing the FLUX GATEWAY must be installed and operation. Testing the FLUX READER can be done by pressing both buttons (IN and OUT) at the same time until the light on the FLUX READER between the buttons turns on: •... -
Page 6: Operating
Replacing batteries In most cases Nedap Flux support will send a replacement Reader when battery levels are low and there should be no need to replace batteries by yourself. If for some reason you do need to replace batteries, follow the... -
Page 7: Flux Gateway
READERs A READER should not be placed directly on metal. Please install a wooden plank of at least 2cm • thick in between. An example of an installation is: FLUX GATEWAY FLUX READER Gateway and ReaderInstallation Manual... -
Page 8: Led Indications For Testing
FLUX GATEWAY is correct. If connection can be made, a blue light will blink briefly. If not, move the FLUX READER closer to the FLUX GATEWAY. If this does not work, please contact support at support@nedapflux.com. - Page 9 Nedap N.V. Parallelweg 2 7141 DC Groenlo The Netherlands...
Need help?
Do you have a question about the FLUX READER and is the answer not in the manual?
Questions and answers