Do you have a question about the ZHX-30-056 and is the answer not in the manual?
Questions and answers
Summary of Contents for MONDAWE ZHX-30-056
Page 1
In Wall Recessed Electric Fireplace USER MANUAL ZHX-36-058/WF-ZHX-RFP-36 ZHX-42-060/WF-ZHX-RFP-42 Model No.: ZHX-60-064/WF-ZHX-RFP-60 ZHX-72-066/WF-ZHX-RFP-72 120V AC / 60Hz / 1500W Read and understand this entire user manual, including all safety information, before plugging in or using this product. Failure to do so WARNING could result in fire, electric shock, or serious personal injury.
1.IMPORTANT SAFETY INFORMATION WARNING: Any use of this appliance other than that recommended by the manufacturer in this owners manual may cause fire, burns, electric shock and/or other serious injuries or death. When using electrical appliance, basic precautions should always be followed to avoid the risk of fire, electric shock and injury to persons including the following: Read all instructions before using this appliance.
Carefully check if any damages that may have for the insert or spare parts. NOTE: Contact service team for help if any part missed or damaged. E-mail:service@mondawe.com; Phone:888-328-5111. During 9:00 to 17:00 EST from Monday to Friday. WARNING: This carton includes GLASS! ALWAYS use extreme caution when handling glass.
Page 7
NOTE: Do not install the glass when testing. Plug it on, check the function as section 5a.Manual Control Panel and 5b. Remote Controls. Should any defects found, please contact service team for help. E-mail:service@mondawe.com; Phone:888-328-5111. During 9:00 to 17:00 EST from Monday to Friday. - 5 -...
4. INSTALLATION INFORMATION Tools Required Phillips screwdriver, A small flat head screwdriver, lectric drill, A 1/4” e A pliers will be needed. Locating the Appliance Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a location, ensure that the general instructions for safety are followed.
Electrical Supply Circuit Requirements Plan the location of the appliance so that it will have adequate electric power. A 15 AMP, 120V/60Hz circuit is required. Additional appliances on the same circuit as this appliance may exceed the current rating of that circuit.Please dedicated circuit is preferred to prevent circuit breaker trips or fuse failure.
Page 10
4.A3) Fix the fixing brackets at both sides by 6pcs Bolt (CC) as shown. Note:The hook hole of the fixing bracket is front. Spare Parts E. Fixing Bracket F. Fixing Bracket Hardware Used CC: Bolt 6PCS 4.A4) Insert the firebox into the opening, adjust the position of unit and Centered.
Page 11
4.A7) Please put Carbon Bed(D) into the furnace electric firebox (A) horizontally, the Carbon Bed(D) not distinguished between the front and the back. Spare Parts D: Carbon Bed 4.A8) Depending on your preference,place faux crystals (G) or log (H.I.J.K) into the base of electric firebox (A).
Carefully set both hooks of the front glass panel in the firebox. NOTE: Make sure the glass is properly installed according to the direction and steps below, and fully attached to the firebox so that the control panel can work properly. 4.A10) Fix the glass front by screws (CC) and complete the installation.
Page 13
Model 30" 36" 42" 50" 60" 72" Overall Size Inch 28-27/64” 34-13/32” 40-25/64” 48-27/64” 58-27/64” 70-25/64” 1026 1230 1484 1788 Inch 5-5/16” 5-5/16” 5-5/16” 5-5/16” 5-5/16” 5-5/16” 4.B2) Fix the fixing brackets at both sides by 6pcs Bolt (CC) as shown. Note:The hook hole of the fixing bracket is the back.
4B.4) With the help of another person, lift the fire box(A) and hang up the fire box onto the wall with the screw(BB). Note:Do not fasten the screws tightly. Leave 1/4” (6mm) spacing. 4B.5~10) The subsequent steps are Flush Mounted Installation same, Refer to step 4A.6~4A.11 of page 8~10.
Page 15
Remove the 2pcs screws to release the Pull the junction box out. Press the screwdriver, cover of junction box. pull the wire out at the mean time to release the wires of power cord. Use a pliers to take the wire clip off and move Insert the hard wires through the BIG hole of the away the power cord.
Page 16
5. OPERATING INSTRUCTIONS Electrical Supply Circuit Requirements Plan the location of the appliance so that it will have adequate electric power. A 15 AMP, 60Hz circuit is required for 120V installation. The appliance should ideally be located close to a suitable main socket to enable power connection. ...
5a. Manual Control Panel Use the control panel: (located in the electric fire box right side) 5a.A) Power: Push button to turn ON or turn OFF. It is invalid to child lock state. The POWER button supplies power to all the features of the electric insert. This button must be ON for any of the features to work properly.
Page 18
Display Carbon color White Amber Green A Green B Green C Green D Blue A Display Carbon color Blue B Blue C Violet A Violet B Violet C Polar Spot Light: 5a.D) Press to Activate the back spot light function,the system will set the spot light, the digital Blue display screen will be shown 08.
5a.H) Display Screen: The Digital Display Screen will display the corresponding numbers of Flame,Carbon Light,Spot Light,Heater,Timer,Child Lock. 5b. Remote Control The remote control can be used up to 13 feet (4 meters) away from the heater, so long as there are no obstructions between the remote control and the heater.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
6. CARE AND MAINTENANCE ALWAYS turn the appliance OFF and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. NEVER immerse in water or spray with water. Doing so could result in ...
7. LIMITED WARRANTY This warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use and proper care, remain so for one year from the date of purchase. Missing or initially defective parts will be replaced free of charge during the period of this limited warranty.
b. If not, unplug the unit and recheck next day to see if it can work properly. c. If still not, the fan assembly need to be checked and please contact service team for a checking instruction. 2) Product has been used for some time: a.
Page 24
Thank you for purchasing this product! Contact the seller if you have any trouble with this product. Website: www.mondawe.com Customer Service: service@mondawe.com Phone: 888-328-5111 - 22 -...
Need help?
Do you have a question about the ZHX-30-056 and is the answer not in the manual?
Questions and answers