Inter Water LED Series Operating Procedures

WARNING
Never operate this Underwater Light for more than 10 seconds unless it is totally submerged
in water. Without total submersion, the light assembly will get extremely hot, which may
result in serious injury to pool users, installers, or bystanders, or in damage to property.
Be sure power is off before installing or removing lamp. Allow lamp to cool before
relamping. This light fixture uses a Halogen Quartz lamp. Do Not touch lamp with bare
hand, this may severely reduce its life. Use the plastic furnished with the replacement lamp
to eliminate finger prints from getting on lamp.
No.
1 M5*20 Screw (316#)
2 Face Ring
3 M6 Brass Nut
4 P100 Lights Face plate
5 Bulb plate 12V/8W LED (White Colour)
6 M6*20 Screw(316#)
7 Concrete pool Fitting for P100
PARTS
Description
Notes: Bulb plate 12V/1W LED
Concrete Pool
LED Series Underwater Light
Qty
1
1
4
1
1
4
1
keep this user manual save for future reference
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
This underwater light fixture must be installed by a licensed or certified electrician or a
qualified serviceman in accordance to the requirements of your government standard or
local authorities. Improper installation will create electric hazards which could result in
serious injury, death as well as damage to the property. Before servicing the light,
disconnect the power supply from the circuit breaker. Failure to do so could result in serious
injury, death and or damage to the property.
Operating Procedures
Please read the following carefully and
DANGER !