Do you have a question about the AVIBG21A and is the answer not in the manual?
Questions and answers
Summary of Contents for AVION AVIBG21A
Page 1
AVIBG21A Modules The AVIBG21A BLE Modules odules are RF Modules built on the EFR32BG21 EFR32BG21A chipset, which provide a single-chip solution to controlling all types of lighting chip solution to controlling all types of lighting chip solution to controlling all types of lighting and other devices, whether line-connecte connected or battery-powered.
Page 9
6. Antennas The AVIBG21A series of Modules are all functionally the same, with the ex are all functionally the same, with the exception of antenna ception of antenna design. In both module configuration module configurations, there are multiple antenna options. Avi , there are multiple antenna options.
Page 10
Added PCB Footprint Keepout & TP Locations Added PCB Footprint Keepout & TP Locations Added PCB Footprint Keepout & TP Locations Updat Updated all MPN to AVIBG21A Updated Module Updated Module Variants to UFL and VIA Versions to UFL and VIA Versions...
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 12
2.4 Limited module procedures Not applicable 2.5 Trace antenna designs Not applicable 2.6 RF exposure considerations To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance of 20cm from your body. 2.7 Antennas This radio transmitter FCC ID: 2AFZI-AVIBG21 has been approved by Federal Communications Commission to operate with the antenna types listed below, with the maximum permissible gain indicated.
Page 13
ISEDC Warning: This device complies with Innovation, Science, and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Page 14
Any company of the host device which install this modular with limit modular approval should perform the test of radiated emission and spurious emission according to RSS-247 and RSS-Gen requirement, only if the test result comply with RSS-247 and RSS-Gen requirement, then the host can be sold legally.
Page 15
This radio transmitter [IC: 20544-AVIBG21] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below: Cet émetteur radio [IC: 20544-AVIBG21] a été approuvé par Innovation, Sciences et Développement économique Canada pour fonctionner avec les types d'antenne énumérés ci-dessous: For model AVIBG21AVIA, the EUT has one monopole antenna arrangement which was permanently attached:...
Need help?
Do you have a question about the AVIBG21A and is the answer not in the manual?
Questions and answers