Table of Contents
Advertisement
5.
Push in the bay locks to secure the
optical drive
6.
Connect a power cable from
the power supply to the power
connector at the back of the optical
drive.
7.
Connect one end of the IDE ribbon
cable to the IDE interface at the
back of the optical drive, matching
the red stripe on the cable with Pin
1 on the IDE interface.
2.7.2
Installing a hard disk drive
The system may have one pre-installed 3.5-inch Serial ATA or IDE hard disk drive.
Refer to this section to install additional Serial ATA or IDE hard disk drive(s).
To install a Serial ATA hard disk drive:
1.
Lift up the secure tab.
2.
Pull out the bay locks.
2-14
35
5
IDE ribbon cable
Power cable
1
2
Chapter 2: Basic installation
Advertisement
Table of Contents
