Subscribe to Our Youtube Channel
Summary of Contents for ReVIVE Luxury Plunge
- Page 1 Luxury Plunge User Manual For any additional questions, please contact us sales@reviveplunge.com Thank you for choosing Revive...
- Page 2 WARNING- ELECTRICITY CAN BE EXTREMELY DANGEROUS. TO PREVENT ACCIDENTS, IT IS ESSENTIAL TO PRIORITIZE SAFETY. PLEASE BE CAUTIOUS WHEN HANDLING ANY ELECTRICAL SYSTEMS. 1.0 Precautions 1.1 Safety ● Before using the plunge, ensure that the local electricity meets the necessary requirements for its operation.
- Page 3 Seasonal ● Summer ● Maximum operating ambient air temperature is 112 degrees Fahrenheit. When ambient temperatures exceed 112 degrees please shut the unit off, or move it to a cooler environment. ● Maintain a well-ventilated environment while the plunge is running. Keeping the plunge in an unventilated area could cause the plunge to overheat and damage the unit.
- Page 4 Preparing Your Plunge ● Once your plunge is in place, remove the compartment door on the side of the unit. When open, you’ll see the unit’s radiator, as well as the unit’s breaker switches, as shown below. Ensure that the breaker switches are in the up position.
- Page 5 ● Along the back interior wall of the side compartment you’ll find two different filters, as shown below. On the right is the metal mesh pre-filter, and on the left is a white cartridge filter. Ensure that both are in place, and the filter housing cups are hand tight.
- Page 6 ● Next, locate the two water valves and ensure that they are open by turning the red lever to be parallel with the water valve. They will be located at the tub inlet and outlet along the back interior wall of the compartment, as shown below.
-
Page 7: How To Operate
Ice Bath Tub User Manual HOW TO OPERATE 1. Turn it on. 2. Adjust the temperature using the up or down buttons. If the set temperature is lower than the actual temperature, the machine will begin cooling the water. Once the set temperature is reached, the compressor will stop. - Page 8 5. Disinfection Control: The water pump activates when disinfection starts and stops after operation “C5.” 6. High and Low Temperature Over-Limit Alarm (set to OFF to disable): After shutdown, if the water temperature exceeds the high limit (C2) or drops below the low limit (C3), the alarm activates after a delay (C4).
-
Page 9: Panel Operation
Panel Operation 1. Control Temperature Adjustment: Press the button to display and change the control temperature, and press it again to change the value. If no key is pressed, the temperature will reset after six seconds (adjustment range: parameter E1-E2). 2.
Need help?
Do you have a question about the Luxury Plunge and is the answer not in the manual?
Questions and answers