Summary of Contents for DAV TECH PT Series
- Page 1 PRESSURE TANK PT COD.: DTVI_PT_2447 TRANSLATED FROM ORIGINAL REV.: 00 Read carefully before use! DATE: 18/11/2024...
-
Page 2: Table Of Contents
MAINTENANCE ..........................23 TROUBLESHOOTING ........................... 25 END OF LIFE ............................ 26 COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. DATE: 18/11/2024... -
Page 3: General Information
If you have any doubts about the interpretation or reading of this document, please contact the manufacturer. DAV Tech declines any responsibility relating to improper use of the component. Observe the specifications in this manual. -
Page 4: Symbology
Qualified technician made available by the manufacturer to carry out operations of a complex nature in particular situations, or in any case as agreed with the customer. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 5: Reference Standards
Failure to comply with this notice will void the CE certification of the tank. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 6: Eu Declaration Of Conformity
USE AND MAINTENANCE MANUAL 1.3 EU Declaration of Conformity Manufacturer's name: DAV Tech Srl Address: Via G. Ravizza, 30, .36075, Montecchio Maggiore (VI) DECLARES UNDER HIS/HER OWN RESPONSIBILITY THAT THE PRESSURIZED COMPONENT Component: PT Tank Model: PT-2; PT-5, PT-10, PT-16... -
Page 7: Glossary
Touch screen that allows the user to interact with a graphic interface using their Touch screen fingers or objects. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 8: Service And Manufacturer Contact Details
(or the service center if present) directly, specifying the identification data of the component. The customer can make use of the technical and commercial support of local agents or importers, who are in direct contact with the company DAV Tech Srl. Company name... -
Page 9: Presentation And Operation
If it is necessary to use several fluids with the same tank, it must be cleaned thoroughly to prevent residues from the previous processing from affecting the work to be performed. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 10: Special Versions
In addition, it is possible that this type of tank is equipped with a stainless steel dip tube with a non-return valve located at the bottom of the tube itself. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 11: Operation
The operation is the same, except that the tube enters directly inside the container and the container itself is pressurized. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. - Page 12 COLOR MEANING CYAN Main Air GREEN Product BLACK Data Notes COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. DATE: 18/11/2024...
-
Page 13: Exploded
The following is a list of the main valve components with spare part numbers. PT-5 PT-5LLS-AN PT-5LLS-STIR COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. DATE: 18/11/2024... - Page 14 This component is replaced by component No.18, float level switch, on request. To be able to put it on, you need the adapter sleeve and the respective rod sensor, which can be capacitive or analogue, of the relative length for the various types of tanks (see point 21 for the various lengths and codes. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law.
-
Page 15: Technical Data
Pressure * Volume is less than 25 (for example, the PT-16 can hold a maximum of 1.5 bar inside). COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. - Page 16 You can request the 3D of the component in the desired version from the manufacturer without any obligation. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law.
-
Page 17: Safety
The component is manufactured in compliance with the technical safety standards in force at the time of its construction. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 18: Machine Safety Devices
If the packaging is not intact, contact the manufacturer immediately, also sending photos of the condition of the packaging. Do not open it until you have notified the manufacturer. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 19: Installation
It is recommended that the component be grounded to prevent a build-up of electrical charges. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 20: Pneumatic
The tube must not be tightened too much otherwise there is a risk of breaking it or choking it too much, affecting the quality of the dosage COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 21: Commissioning
Commissioning should only be carried out when all points have been successfully completed. 6 SOFTWARE N.A. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 22: Procedure
The lid must be raised to the necessary length so that these components do not get damaged. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 23: Container Change In The Tank
9. Turn the pressure reducer clockwise gradually and check for leaks. If so, proceed and bring the reducer to working pressure. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 24: Changing Dip Tube
The tube must not be tightened too much otherwise there is a risk of breaking it or choking it too much, affecting the quality of the dosage COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. -
Page 25: Maintenance
The times given below are indicative as they depend on how the component is used. Follow the variations suggested by the technicians. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. - Page 26 In addition, all gaskets are made of NBR, unless otherwise agreed with the manufacturer. In this case, contact the manufacturer directly. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law.
-
Page 27: Troubleshooting
Remove pressure from the component tank high and contact the manufacturer COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law. DATE: 18/11/2024... -
Page 28: End Of Life
We recommend that you commission specialist companies for this purpose and must always observe the applicable laws on waste disposal. COD.: DTVI_PT_2447 DAV TECH SRL REV.: 00 Any reproduction (total or partial) of this document not authorized by the manufacturer will be punished according to the law.
Need help?
Do you have a question about the PT Series and is the answer not in the manual?
Questions and answers