Alemlube 63116 Owner's Manual

Digital Tyre Inflator with Built-In Air Compressor (Outdoor)
!
READ INSTRUCTIONS BEFORE OPERATING
INTRODUCTION
Congratulation on selecting the tyre Inflation Equipment.
This equipment has a number of unique features that are explained
in this manual. Please review the information provided to ensure your
safety & prevent damage to the product.
CAUTION
The misuse & unsafe practice could result in injury or death.
WARNING
The hazard or unsafe practice could result in severe injury or death.
GENERAL SPECIFICATIONS
Power Requirement
Operating Temperature without Heater 41ºF to 113ºF, 5°C to 45°C
(Options Available: Additional heater)
Internal oil-less Air Compressor
Maximum Pressure
Inflator Operating Pressure
Accuracy
Display Increments
Units of Measurement
Note: Specifications may vary for non-standard equipment.
Contact service agent for further information.
ASSEMBLY
1. Unpack the unit.
Description Quantity
Main Unit 1
2. Hold the unit up and mark where the four (4) holes are to be drilled.
3. Secure the unit on the floor using suitable fasteners onto the four (4)
holes at the bottom of the unit.
PREPARATION FOR USE
1. Open the unit left panel.
2. Connect the power supply. Turn on the power switch inside the unit to power
up the unit.
3. The equipment is now ready to use.
NSW/ACT (02) 9677 1555
WA (08) 9302 4199
OWNER'S MANUAL
240Vac 50hz
102 psi, 700 kPa, 7bar
Minimum 5 psi, 35mkPa, 0.3bar,
Maximum 75psi, 500kPa, 5.0bar
+/-1 psi, 7kPa, 0.07bar
1 psi, 5kPa, 0.1bar
psi, kPa, bar
QLD/PNG (07) 3491 2600
SA/NT (08) 8241 7111
VIC/TAS (03) 8787 8288
NZ (09) 447 1007
63116
August 2024
www.alemlube.com.au
www.alemlube.co.nz
1