Let’s talk safety This vacuum cleaner is intended for household use only and NOT for commercial or industrial use. READ ALL THE INSTRUCTIONS BEFORE USING THIS APPLIANCE. • This appliance is battery-operated, and the battery is charged whilst inside the Basic appliance.
Page 3
• Only use the vacuum cleaner indoors and keep the area you’re cleaning well lit. • Only Dirt Devil recommended tools and accessories should be used with this vacuum cleaner. • This vacuum cleaner does not stay upright without constant support, in between uses lie flat on the floor in a suitable location so it does not become a trip hazard or can be stepped on.
Page 4
Thank you for purchasing the Dirt Devil Cordless Vacuum The Dirt Devil Cordless Vacuum is designed to make vacuuming carpets and hard floors as easy and convenient as possible, this user guide will help you get the most out of your machine.
Contents Included with your machine Let’s talk safety 2-in-1 Tool Getting to know your machine Getting started Charger Using your machine Support Bracket & Screws Taking care of your machine All models include warranty sheet and a user guide. Contents may vary. Pictures shown are for illustration purpose only.
Getting started PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE Before you begin CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the handheld/attachments or removing and emptying the dust bin. IMPORTANT: For best cleaning results, empty the dust bin after each use. The filter should be tapped over a bin every 4-6 uses, to remove dirt and debris, and replaced every 6-9 months, depending upon use.
Getting started Installing the support bracket NOTE: The support bracket should be installed near a power supply where the charger cord can extend from the vacuum down to the plug in the wall. IMPORTANT: The support bracket is not designed to hold the full weight of the vacuum. The floor head should be positioned flat on the surface of the floor to support the weight of the vacuum while the wall mount positions the vacuum in the upright position.
Getting started PLEASE READ ‘LET’S TALK SAFETY’ BEFORE USE CAUTION: The battery used in this device may present a risk of fire or chemical burns if mistreated. Do not disassemble, crush, incinerate or expose to high temperatures above 38°C. The battery is not a replaceable part. Use of another battery may present a risk of fire or explosion.
Page 10
Getting started Charging the battery WARNING: Do not attempt to use the vacuum cleaner when the machine is plugged in and charging. WARNING: For best performance the charging port must be clean and free from dust and dirt. The life expectancy of the battery will vary depending on the usage of the vacuum cleaner.
Using your machine Using your vacuum cleaner CAUTION: This vacuum cleaner has a constantly rotating brushbar, which is activated when the vacuum is switched on. Never leave the vacuum cleaner in one spot for an extended period of time as this may damage the floor surface. CAUTION: Ensure that the vacuum is switched off before performing maintenance or troubleshooting checks.
Using your machine Emptying the dust bin WARNING: Don’t over fill the dust bin to avoid blocking the air flow through the vacuum cleaner. Do not exceed the MAX line indicated on the side of the dust bin. Ensure that the vacuum Hold the dust bin over a is switched off.
Taking care of your machine Cleaning and replacing the filter CAUTION: Ensure that the vacuum is switched off before performing maintenance or troubleshooting checks. For continuous best performance, the filter should be tapped over a bin every 4-6 uses, to remove dirt and debris, and replaced every 6-9 months, depending upon use.
Page 14
Taking care of your machine Removing and replacing the brushbar IMPORTANT: If the brushbar has been obstructed, the Motor Protection Sensor may have been activated and the brushbar will stop. Remove the floor head from the machine and clear any obstruction. Refit the floor head, switch on the vacuum cleaner.
Taking care of your machine Checking for blockages CAUTION: Ensure that the vacuum is switched off before performing maintenance or troubleshooting checks. Remove the brushbar To test for a blockage in Check the dust bin inlet from the floor head and the wand, drop a small for blockages.
What to do if it goes wrong Problem Solution • Check the contents panel on the box to make sure the part is included with your vacuum cleaner. Is there an accessory missing? • The machine, floor head and wand may not be correctly fitted. Go to ‘Getting Started’. •...
Need help?
Do you have a question about the DSV22G2 and is the answer not in the manual?
Questions and answers