IRIT IR-3233 Manual Instruction

MANUAL INSTRUCTION
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ
Ear and Nose Hair Trimmer
Триммер для носа и ушей
IR-3233
Description
1 - Protective Cap
2 - Outer Blade frame
3 - Inner Blade
4 - Power Switch (ON/OFF)
5 - Body
6 - Battery Cover
7 - Brush
Attention!
The appliance is not intended for professional use.
IMPORTANT SAFEGUARDS
● Please read the owner's manual carefully before using the product.
● Under no circumstances must the device be placed in water or other liquid,
or come into contact with such.
● To avoid injuries, do not use the device if it has any damages.
● Contact to qualified service center if the trimmer does not work properly.
● Always use the device for its intended use as it is described in this manual.
● The trimmer is for nose and ears haircut only
● Keep the device out of reach of children.
● If the trimmer is not used for a long time, remove the batteries.
● Do not leave appliance unattended.
● Do not leave the appliance for animal grooming.
● The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their safety.
1 2 3 4 5
7
Using
Powered by one AA-size battery, 1.5 V (not included):
1. Remove the battery cover,
2. Insert the batteries
3. Turn the trimmer, using the switch on the front panel trim.
Trim the nose hairs
Switch on trimmer and carefully insert it into the nostril, but no more
than half centimeters. Remove hair in nose with smooth circular
motion. Cycle time: up to 3 minutes.
Trim the ear hairs
Do not insert ear trimmer for more than half centimeter, because
it can cause damage of the eardrum!
Cleaning
● Clean the trimmer after each use.
Make sure that the battery compartment tightly closed trimmer should
●
be switched off during cleaning remove the cap from the trimmer
and pull cutting head, as shown in the figure - rotate clockwise
and pull up.
Clean the head using included brush
●
After cleaning, put it in place.
6
Put on a cap on the cutting head
●
Replacing battery
Turn the battery compartment cover and pull it to remove.
Insert one AA battery (1.5V), observing correct polarity.
Place the battery compartment cover back.
The importer retains his right to make changes in appearance and
completeness of the item without preliminary notification to the customer.
For household usage only.
RATED PARAMETERS
Powered by a single AA battery (1,5 V). Batteries not included
The date of manufacture is marked on the packaging.
The importer retains his right to make changes in appearance
and completeness of the item without preliminary notification
to the customer.
For household usage only.
Do not leave unattended!
Service life is 2 years
Made in China