GE Cafe CDD420P3TD1 Installation Instructions Manual

Installation Instructions
If you have questions, visit GEAppliances.com, or call GE Appliances at 833-4BODEWELL (833-426-3393).
BEFORE YOU BEGIN - Read these instructions completely and carefully.
WARNING
To reduce the risk of electric shock, fire, or injury to persons, the installer must
ensure that the dishwasher is completely enclosed at the time of installation.
FOR PERSONAL SAFETY: Remove house fuse or open circuit breaker before
beginning installation. Do not use an extension cord or adapter plug with this
appliance.
The improper connection of the equipment grounding conductor can result in a
risk of electric shock. Check with a qualified electrician or service representative
if you are in doubt that the appliance is properly grounded.
If house wiring is not 2-wire with ground, a ground must be provided by the installer.
When house wiring is aluminum, be sure to use UL-Listed anti-oxidant
compound and aluminum-to-copper connectors.
To reduce the risk of electric shock, fire, or injury to persons, the installer should
check to ensure that wires are not pinched or damaged, the house wiring is attached
to the dishwasher through a strain relief, and all electrical connections made at
the time of install are contained inside of the terminal block cover.
For models equipped with power cord: Do not modify the plug provided
with the appliance; if it will not fit the outlet, have a proper outlet installed by a
qualified technician.
CAUTION
While performing installations described in this booklet, gloves, safety glasses
or goggles should be worn.
FOR YOUR SAFETY
Read and observe all WARNINGS and CAUTIONS shown throughout these
instructions.
IMPORTANT – Observe all governing codes and ordinances.
Note to Installer – Be sure to leave these instructions for the consumer's and
local inspector's use.
Note to Consumer – Keep these instructions with your Owner's Manual for
future reference.
Skill Level – Installation of this dishwasher requires basic mechanical, electrical
and plumbing skills. Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered under the
GE Appliances Warranty. See Warranty information.
Completion Time – 1 to 3 Hours. New installations require more time than
replacement installations.
IMPORTANT – The dishwasher MUST be installed to allow for future removal from
the enclosure if service is required.
Care should be exercised when the appliance is installed or removed, to reduce the
likelihood of damage to the power supply cord.
If you received a damaged dishwasher, you should immediately contact your dealer
or builder.
Your dishwasher is a water heating appliance.
CAUTION
Opening a drawer will cause the dishwasher to tip forward
when it is not fully installed. When opening a drawer prior to
the dishwasher being fully installed, hold the drawer handle
securely with one hand and the top of the dishwasher with the
other hand. Gloves should be worn.
READ CAREFULLY
KEEP THESE INSTRUCTIONS
Dishwasher Drawer