Summary of Contents for Innovative LuxeLift
- Page 1 Assembly and Care Instructions LUXELIFT BIDET Powered Toilet Lift Contact www.innovahometech.com info@innovahometech.com (267) 909-4606...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS When using an electrical furnishing, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING ELECTRIC TOILET LIFT SAVE THESE INSTRUCTIONS Danger To reduce the risk of electric shock: Always unplug this furnishing from the electrical outlet before cleaning or servicing. ▪... - Page 3 DIMENSIONS...
-
Page 4: Key Features
KEY FEATURES Ergonomic Angled Handles with Rubber Grips SOS Alarm Button Wide Armrests UP/DOWN Button Built-in bidet with adjustable water temperature, pressure, and nozzle position. • Heated, illuminated seat with adjustable blow dry temperature and automatic deodorizing. 350lbs Weight Capacity Height Adjustable Legs Convenient... -
Page 5: Components Included
COMPONENTS INCLUDED A. 1X A. LuxeLift Base Assembly B. 1x Right Hadle (with Controls) C. 1x Left Handle (with SOS Button) D. 2x Armrests E. Bidet Remote Controller F. 4x Legs G. Hardware Kit H. Up/Down Remote Controller I. T-fitting (7/8x7/8x1/2-in) J. - Page 6 ▪ Verify that all necessary components are included and check for any damage or issues. ▪ If any parts are missing, damaged, or not functioning, contact Innovative Home Technologies immediately. Organize all components in a clear workspace to streamline assembly.
- Page 7 Step 4: Align and Secure the Handles ▪ Ensure both handles fit securely onto the posts. ▪ Align the screw holes on the handles with the holes on the base. Step 5: Tighten the Screws Insert the provided M5x12mm screws (2 per handle) with plastic washers into the aligned holes. ▪...
- Page 8 Step 8: Install the Adjustable Feet Screw the Feet: Attach the adjustable feet to the bottom of the lift. ▪ Adjust Height: Turn the feet to raise or lower the lift. ▪ Ensure the rear support of the lift is slightly higher than the toilet rim (approximately ⅛” to ¼”). Secure the Feet: Tighten the nut at the top of each leg to lock the feet in place.
-
Page 9: Connecting The Water Supply Line
Connecting the Water Supply Line Warning Important Safety Instructions Connect the water supply line to the product only after the LuxeLift has been fully assembled and installed. ▪ Do not overtighten compression hose fittings. ▪ ▪ Product must be connected to a cold water supply with a maximum pressure of 100 psi. - Page 10 Step 3: Assemble Water Filter and T-fitting Attach the Water Filter: ▪ Hand-tighten the provided water filter to the T-fitting (no tools required). Ensure the provided rubber washer is in place. Do not overtighten. Connect the T-Fitting to the Toilet Tank: ▪...
- Page 11 Step-by-Step Installation Instructions Step 1: Remove the Existing Toilet Seat Carefully remove the original toilet seat and lid, leaving only the bare ceramic bowl exposed. ▪ Step 2: Prepare for Installation Use the lift's control to raise it, providing better access to the installation area. ▪...
- Page 12 Step 5: Final Alignment and Securing ▪ Ensure the brackets are properly aligned. ▪ Tighten the bolts securely to stabilize the lift. Slide the rear support cover back onto the crossbar to complete the installation. ▪ Step 6: Connect water hose to the inlet located in the back of lifting base Do not overtighten.
- Page 13 ▪ control. ▪ Before use, ensure that the LuxeLift is connected to an GFCI-protected electrical outlet and the water inlet valve is in the open position. The Side Knob should be illuminated; if it is not, press the knob. ▪...
-
Page 14: Remote Controller
Remote Controller Nozzle Clean Rear Wash: ▪ Press once to activate the automatic nozzle ▪ Press once to start rear washing. cleaning function. Press again to activate the back-and-forth ▪ After the automatic cleaning is complete, nozzle movement. ▪ you can use a soft brush or pad to clean ▪... - Page 15 Bidet Side Knob Controls The bidet is in Idle Mode when the knob is not lit, and all functions are disabled. You must be seated to deacti- vate Idle Mode. Front Wash: Turn the knob clockwise to activate the automatic Front Wash, which will last for one minute. ▪...
-
Page 16: Care And Cleaning Instructions
Avoid using hard or sharp objects that may scratch or damage the lift’s surface. ▪ ▪ If any issues or defects are found, contact Innovative Home Technologies, LLC for warranty service or repairs. By following these care and cleaning guidelines, you’ll ensure your EaseLift Toilet Lift remains safe, clean, and in... -
Page 17: Troubleshooting
Battery level is low Replace batteries Remote controller is not Defective Remote Controller Contact Innovative Home Technologies working Additional Assistance If the problem persists after trying the solutions above, please contact our customer support team for further assistance or arrange for professional servicing. -
Page 18: Limited Warranty
Welds: A Lifetime Warranty on all welds, ensuring long-lasting durability and safety. If a defect arises, Innovative Home Technologies, LLC will repair or replace the affected product or part at no cost to you, using either new or refurbished parts. Our goal is to ensure your satisfaction and keep your equipment operating like new. - Page 19 COMFORT WHERE INNOVATION MEETS www.innovahometech.com info@innovahometech.com (267) 909-4606 Purchase Date: Order#: Installation Date: THANK YOU...
Need help?
Do you have a question about the LuxeLift and is the answer not in the manual?
Questions and answers