Advertisement
Quick Links
KeyPad-Touch – MANUAL (ARCHIVE) | 1
Legacy product
This product is no longer available. The documentation is still available as an archive.
ORDER-CODES:
KKPT
The KeyPad is used to arm-disarm the AlarmManager on site. Like the MultiSensors, the KeyPad
keyboard is integrated into the ZigBee© wireless network of the AlarmManager. Note, however, that
the keyboard does not work as a router and cannot affect the range of the network.
The KeyPad turns on when any key is pressed. The maximum operating time is then approx. 10
seconds. Within this time, an assigned alarm zone can be armed or disarmed.
Safety instructions
Installation
Installation and commissioning may only be carried out by trained specialist personnel in accordance
with the instructions.
© Kentix GmbH. This file was automatically generated on 2025-01-07 20:17:52. Please visit
docs.kentix.com
for the
latest documentation.
Advertisement
Related Manuals for Kentix KKPT
Summary of Contents for Kentix KKPT
- Page 1 Within this time, an assigned alarm zone can be armed or disarmed. Safety instructions Installation Installation and commissioning may only be carried out by trained specialist personnel in accordance with the instructions. © Kentix GmbH. This file was automatically generated on 2025-01-07 20:17:52. Please visit docs.kentix.com for the latest documentation.
- Page 2 Kentix accepts no liability for damage to the equipment or components resulting from incorrect installation. No liability is accepted for incorrectly programmed units. Kentix shall not be liable in the event of malfunctions, damage to property or other damage. Use of the products, transport and storage Protect the device during transport, storage and operation from Protect moisture, dirt and damage.
- Page 3 Not OK: 3 seconds acoustic signal (on/off), LED for arming flashes red Disarming – enter room © Kentix GmbH. This file was automatically generated on 2025-01-07 20:17:52. Please visit docs.kentix.com for the latest documentation.
-
Page 4: Internal Controls
To add a KeyPad touch to KentixOne, select “+” in the Alarm Zones heading area of the Dashboard, then select “MultiSensor (Wireless)”. Press the teach-in button for 3 seconds, which you reach via the recess on the back of the housing © Kentix GmbH. This file was automatically generated on 2025-01-07 20:17:52. Please visit docs.kentix.com for the... - Page 5 Before you start the configuration, make sure that the software is up to date on all network-enabled Kentix devices. The version status must be the same on all devices. You can download the latest software here: KentixONE © Kentix GmbH. This file was automatically generated on 2025-01-07 20:17:52. Please visit docs.kentix.com for the latest documentation.
Need help?
Do you have a question about the KKPT and is the answer not in the manual?
Questions and answers