Anti-Tip Bracket Installation; Microwave Oven Placement - Whirlpool BUILT-IN TRIM KIT Installation Instructions Manual

NOTE: Remove any dirt or oil on microwave oven surface before
ducts are attached.
3. Peel off backing of double-sided tape. Attach the side duct
and upper duct assembly to left side of microwave oven
cabinet. Press down firmly on ducts. Fasten duct assembly to
cabinet with existing screw.
A
A. Existing screw

Anti-Tip Bracket Installation

1. On cutout floor, use template to mark hole centers for anti-tip
bracket. Be sure to align the centerline of template to
centerline of cutout floor.
(Dimensions as shown are not to scale.)
A
B
C
D
A. Cutout opening
B. " (2.06 cm)
C. 3" (7.62 cm)
2. Drill 2 holes for anti-tip bracket. (Use
3. Install anti-tip bracket onto cutout floor using two
A
B
A. " screws
B. Anti-tip bracket
4
E F
D. 16 " (42.55 cm)
E. Centerline
F. Cutout floor
" drill.)
" screws.

Microwave Oven Placement

1. Slide microwave oven partway into cutout opening.
NOTE: Bottom bracket must be flat against cutout floor in order
to correctly engage with anti-tip bracket.
A
B
C
A. Bottom duct
B. Anti-tip bracket
C. Bottom bracket
2. Plug in microwave oven.
3. Make sure microwave oven is centered within cutout opening
and slide it into place, engaging anti-tip bracket.
4. Drill pilot holes through positioning flange. (Use
Then install three " screws at front of bottom duct.
A
B
C
A. Cutout opening
B. Positioning flange
C. " screws
" drill.)