Table of Contents
Advertisement
Quick Links
E Schaudt GmbH, Elektrotechnik und Apparatebau, Planckstraße 8, 88677 Markdorf, Germany, Tel. +49 7544 9577-0, Fax +49 7544 9577-29, www.schaudt- -gmbh.de
8110268 BA / EN
Operating Instructions
Electroblock EBL 227
Electroblock EBL 227 with OVP
Table of contents
1
1.1
1.2
1.3
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.1
3.2
3.3
3.4
3.5
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4
4.1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.2
4.3
5
5.1
5.2
5.3
6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2
2
2
3
3
4
4
5
7
8
9
11
11
12
13
14
14
14
15
15
16
Date: 06.08.2021
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Lippert EBL 227
-
Page 1: Table Of Contents
Operating Instructions Electroblock EBL 227 Electroblock EBL 227 with OVP Table of contents Safety information ........ -
Page 2: Safety Information
Operating Instructions EBL 227 Safety information Meaning of safety symbols DANGER! Failure to comply with this sign may result in danger to life or physical con- dition. WARNING! Failure to comply with this sign may result in injury. ATTENTION! Failure to comply with the sign may result in damage to equipment or other connected consumers. -
Page 3: Liability Limitation
Operating Instructions EBL 227 Liability limitation All technical information, data and instructions pertaining to installation, ope- ration and maintenance contained within this operating manual and associa- ted installation guide were up-to-date when the documents were printed, and were compiled in good faith in due consideration of experience and findings gained previously. -
Page 4: Operation
Operation of the electroblock is not required for daily use. Settings only have to be configured when the battery type is changed (lead- gel, lithium or AGM), during initial start-up or when retrofitting accessories (refer to Section 3.2 and the installation instructions EBL 227). Switching system on/off ATTENTION! Incorrect electroblock settings. -
Page 5: Changing The Battery
Electrically isolate the battery from the electroblock. For this, activate the " battery cut-out (refer also to Section ”Shutdown”, 3.5). Remove the ”Solar” (Block 3) connector on the EBL 227 (if available). " Isolate the electroblock from the mains voltage (230V AC). - Page 6 ”Lith./Gel”, enables the BMS for the lithium battery to charge it accordingly (also refer to Section 5.2). Starting up Plug in the ”Solar” (Block 3) connector on the EBL 227 (if available). " the system Start up the system as described in section 3.1.
-
Page 7: Operation With Booster
Block 1 Pin 2 at the output of the booster (output voltage of booster) Block 1 Pin 1 to the ground connector of the booster Move the ”Booster mode” switch (Fig. 2 Pos. 1) on the EBL 227 into posi- "... -
Page 8: Operating Faults
Operating Instructions EBL 227 Faults Flat A fault in the power supply system is usually caused by a blown fuse. vehicle fuses Please contact our customer service address if you cannot rectify the fault using the following table. If this is not possible, such as when you are abroad, a specialist workshop will be able to repair the device. -
Page 9: Shutting Down The System
Operating Instructions EBL 227 Fault Possible cause Remedy No 12 V supply in the lei- Leisure area battery vol- Performs a mains charge sure area tage is too low -- the bat- or start the engine. tery monitor has activated... - Page 10 Operating Instructions EBL 227 Isolate the leisure area Disconnect the leisure area battery from the 12V power supply when the battery from the motorhome is not used for a longer period (during the winter for example). on-board 12 V supply For this, the system has a battery cut-out mechanism which isolates electri- cally the leisure area battery from the vehicle.
-
Page 11: Application And Functions In Detail
12 V consumers battery Fig. 3 On-board power supply system Modules The EBL 227 electroblock comprises: a charge module for charging all batteries connected the complete 12V distribution unit the fuses for the 12V circuits a main switch module battery monitor... -
Page 12: Battery Functions
Operating Instructions EBL 227 Battery functions Suitable batteries Refer to the charging curve; 6-cell AGM or lead-gel batteries (or suitable lithium LiFe-Po4 with own bat- tery management system BMS), from 80 Ah Battery cut-out The battery cut-out (activated from the panel, also refer to Section 3.5) isola-... -
Page 13: Additional Functions
5 A when the 230 V mains is connected to the electroblock. Tank probe/sensor The EBL 227 has connectors for 2 tank sensors, one for fresh water (FW) inputs and one for waster water (WW). Each sensor has a base electrode and 4 le- vel electrodes (25%, 50%, 75% and 100%). -
Page 14: Technical Details
Operating Instructions EBL 227 Technical details Mechanical details Dimensions 130 x 275 x 170 (H x W x D in mm), including attachment feet Weight 2.0 kg Housing PA (polyamide), gentian blue (RAL 5010) Front Aluminium, powder coated, light grey (RAL 7035) -
Page 15: Environmental Parameters
Operating Instructions EBL 227 charge Main charge Full charge Trickle charge Lead-gel:14.4V AGM: 14.7 V Lead-gel:13.7V AGM: 13.7V 16 h for lead-gel 4 h for AGM Time Fig. 4 Charging voltage curve with electroblock EBL 31 Main charge with maximum 18 A charging current, electronically limi- ted, up to final charging voltage. -
Page 16: Appendix
They would bypass the current measurement and so could cause erroneous charging of the battery. All consumers and chargers (solar regulators, audio devices, etc.) must therefore be connected to the connectors on the EBL 227. Customer service Customer service Schaudt GmbH, Elektrotechnik &... -
Page 17: Fault Report
Operating Instructions EBL 227 Fault report In the event of damage, please fill in the fault report and send it with the faulty device to the manufacturer. Device type: _______________________ Part no.: _______________________ Vehicle: Manufacturer: _______________________ Model: _______________________ Own installation? - Page 18 Operating Instructions EBL 227 Layout Fig. 5 Layout of the EBL 227 electroblock (front) Pos. Name Meaning Installation feet (4 x) Bl. S1 Block S1 -- Microfit 6F Sensor for fresh water Bl. S2 Block S2 -- Microfit 6F Probe/sensors for waste water...
- Page 19 Operating Instructions EBL 227 Fig. 6 Layout of EBL 227 electroblock (rear) Pos. Name Meaning + Red Terminal Starter battery connector -- Brown Terminal Common ground + Black Terminal Leisure area battery connector Date: 06.08.2021 8110268 BA / EN...
- Page 20 Operating Instructions EBL 227 Block/connection diagram (I of II) Battery type: Off: AGM On: Lith./Gel Negative, leisure area Charging module battery must be connected Mains Booster mode externally 230 V ~ 50Hz Off: with booster Negative, starter On: without booster battery.
- Page 21 Operating Instructions EBL 227 Block/connection diagram (II of II) Section-sensor - - Section-sensor - - Section-sensor - - Sig. Molex Microfit 6F - - Block S1 Circuit board EBL 227 ST full See Sheet 1 Water Base n.c. Molex Microfit 5F - - Block S2...
- Page 22 Operating Instructions EBL 227 (Blank page) Date: 06.08.2021 8110268 BA / EN...
Need help?
Do you have a question about the EBL 227 and is the answer not in the manual?
Questions and answers