Summary of Contents for Matchless Ignite Cart
- Page 1 Ignite Cart - Setup Phone: Phone: 913-214-1518 913-214-1518 Rev. 3 Rev. 3 Email: Email: info@matchlesscabinet.com info@matchlesscabinet.com 08-2024 08-2024...
-
Page 2: Cleaning And Care
In addition, wet ash can become corrosive over time, so keep all surfaces free of ash debris. CAUTION – Appliance and stainless steel cleaning solvents are harmful to your Matchless Cabinet product’s finish and should not come in contact with the surface at any time. Take care to spray the solvent onto a cloth and wipe only on the appliance surface. - Page 3 1. Attach the wheels or leg kit to the bottom of the cabinet with the included hardware; then place the unit right-side up 2. The Ignite Cart will hold a 20lb liquid propane tank in the middle storage cupboard. To utilize this access, you must first remove the knockout panel in the floor, and then place the LP tank into position.
- Page 4 Assembly 3. Gas lines and electrical may be routed between the shelf partition and the (removable) back wall. There is also a small knockout panel located near the front that may be removed for Blackstone Models 6028 and 6301 (which will align to the Tabletop Griddle Insert;...
- Page 5 Assembly 4. If installing a standard built-in grill, first place the included front trim into the cart’s grill opening. Attach on the sides and bottom with the included M10 self-tapping screws. Your particular trim may vary in appearance, based on the model of grill being installed.
- Page 6 Assembly 5. If using our Tabletop Griddle Insert (for Blackstone, Halo, or other griddles), slide that into the opening and secure with three included M10 self-tapping screws, using an extension bit to reach. Screw through access holes 6. With care, install grills per the manufacturer specifications. 7.
Need help?
Do you have a question about the Ignite Cart and is the answer not in the manual?
Questions and answers