Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for iteco 7914.278
- Page 1 S.N. 7914.278/279 English VACUUM BAG SEALER Instruction manual...
-
Page 2: Safety Instructions
Always use fuses complying with safety standard in force, and with correct value and dimensions. EC CONFORMITY Units 7914.278 and 7914.279 conform to EC directives 2004/108/EC e 2006/95/EC , the following harmonized standards are in use EN 60204-1, EN 61000-6-1, EN 61000-6-3. A weighted sound pressure <70dB (A) A weighted sound power <... -
Page 3: Technical Data
Repairs have not been attempted by anyone other than authorized repair distributors. Do not try to repair the unit by yourself. ATTENTION: Dangerous voltage is present inside the unit. 2 - TECHNICAL DATA Code 7914.278 7914.279 Stainless steel Stainless steel Costruction... -
Page 4: Installation
4 - INSTALLATION Remove the package and check hat machine is undamaged. In particular, look for possible damages caused by transport. If in doubt, do not use the machine and refer to Iteco. Place Position the machine in a place with low humidity percentage and far from heat sources. -
Page 5: General View
5 - MACHINE AND CONTROLS DESCRIPTION GENERAL VIEW Stainless steel external structure Aluminium lid Stainless steel chamber Aluminium hinge Silicone sealing counter-bar Line main switch Display Digital control panel Inert Gas Input Conductive wheels CONTROL PANEL VACUUM SEAL COOLING OPENING STOP POWER VACUUM... -
Page 6: Preliminary Operations
1 "STOP" . If this button is pressed during the work cycle, the machine discharges. The LED signals the presence of supply voltage. 2 "VACUUM" button, the vacuum % value appears on the display. If this button is pressed for 2 seconds, the programming mode is activated and the number will blink on the display. -
Page 7: Use Of The Machine
USE OF THE MACHINE Use “VACUUM MOISTURE BARRIER BAG” only Vacuum type bags, because are made from multilayer film and not from plastic extrusion, always have two lateral soldered stripes. note 1) Introduce the piece to be packaged into the bag. 2) Place the opening of the bag as in the picture below. - Page 8 PRESETTED PROGRAMS It is possible to memorize 10 sealing programs for frequently used bags and materials. To recall a presetted program press the key, display will show the program number to recall, select the desired program through , then press again .
Need help?
Do you have a question about the 7914.278 and is the answer not in the manual?
Questions and answers