Page 4
Mechanism: Horizontal and Vertical Position Adjustment of Boom Arm (If required): Loosen the adjusting nuts. Adjust the turning screw to make the boom arm perpendicular to the ground in open position and parallel to the ground in closing position. Tighten the adjusting nuts once boom arm position is set as required.
Remotes Learning/ Pairing: a) Learning Remote Code Press “LEARN” button on the main board for one second, the LED will illuminate, then press the button you desire on the remote for one second. the LED will flash. Repeat these steps for more remotes. Note: 1.
Page 7
Loop Detector Connections as a Safety Device: SGA Loop Detectors can also be used to prevent the closing of boom gate until the vehicle is over the induction ground loop. It must be used in conjunction with the specific loop detector cable.
Page 8
Connecting PE Sensor Receiver/ Retro Reflective Sensor (SGA-RR11): Blue (V-) and Yellow (GND) Black (NO/ Not Used) Brown (V+) White (NC/ PHOTO) W: skylinegateautomation.com.au...
Need help?
Do you have a question about the SGA-BG-DC and is the answer not in the manual?
Questions and answers