Freestyle EncloSure Installation Instructions Manual

Screen door
Hide thumbs Also See for EncloSure:

Advertisement

Installation Instructions
English ....................................................................................... 1
Français ..................................................................................... 6
Español ....................................................................................11
Read all instructions prior to installing product.
Refer to manufacturers safety instructions when operating any tools.
To register your product, please visit:
EncloSure™
Screen Door
oldcastleapg.com/registration
WEB REV 1.25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EncloSure and is the answer not in the manual?

Questions and answers

Summary of Contents for Freestyle EncloSure

  • Page 1 WEB REV 1.25 EncloSure™ Screen Door Installation Instructions English ..................1 Français ..................6 Español ..................11 Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. oldcastleapg.com/registration To register your product, please visit:...
  • Page 2: Before You Begin

    WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. •...
  • Page 3 Step 1: Cut Left and Right Z-Bar to length Facing the house from the outside, measure the height of the top of the threshold (Fig 1A). Using that dimension, m and RIGHT Z-bars to the same length (Fig 1B). Keep thi Fig.
  • Page 4 screw in the last hole (Fig 5C). You could use (9) - (11) #8x1” screws depending on actual door size. screws in the top three holes, and then every other hole to secure the hinge. Always be sure there is a screw in the last hole (Fig 5C).
  • Page 5 Cut and Install Adjustable Bug Sweep Step 7: Cut and Install Adjustable Bug Sweep Fig. 5 Close door and measure from the door edge on the latch side to Z-bar minus 1/16” (Fig 7). Cut channel to width. A. Close door and measure from the Step 7: Cut and Install Adjustable Bug Sweep door edge on the latch side to Z-bar minus 1/16" (Fig. 5). Cut channel to...
  • Page 6: Instructions D'installation

    WEB REV 1.25 Porte Moustiquaire EncloSure™ Instructions d’installation English ..................1 Français ..................6 Español ..................11 Lire toutes les instructions avant d’installer le produit Consulter les consignes de sécurité du fabricant avant d’utiliser des outils. oldcastleapg.com/registration Pour enregistrer le produit, visiter :...
  • Page 7: Avant De Commencer

    AVERTISSEMENT : • Une mauvaise installation du produit peut causer des blessures. Toujours porter des lunettes de sécurité lors de la coupe, du perçage et de l’assemblage du produit. • Une installation incorrecte est susceptible de causer des dommages au produit ou des blessures à la personne qui en fait l’installation AVIS : • NE PAS assembler le produit s’il y a des pièces manquantes ou endommagées. • NE PAS retourner le produit au magasin. Pour obtenir de l’aide ou des pièces de remplacement, composer le : 1-877-265-2220. AVANT DE COMMENCER OUTILS NÉCESSAIRES : 1. Installe-t-on une porte de GAUCHE ou de Ruban à mesurer DROITE ? Crayon Ce kit peut être utilisé pour des installations de Perceuse gauche ou de droite. Ces instructions illustrent Foret à...
  • Page 8 Step 1: Cut Left and Right Z-Bar to length Facing the house from the outside, measure the height of the top of the threshold (Fig 1A). Using that dimension, m and RIGHT Z-bars to the same length (Fig 1B). Keep thi Fig.
  • Page 9 Open the piano hinge and place it against right side Z-Bar “Hinge-guide Rail” (Fig 5A), down 1/8” to Step 5: Install Side Expander/Piano Hinge Assembly 3/16” from the Z-Bar header. This measurement will determine your final reveal (Fig 5B). Use #8x1 Open the piano hinge and place it against right side Z-Bar “Hinge-guide Rail”...
  • Page 10 Couper et installer le coupe- Step 7: Cut and Install Adjustable Bug Sweep Fig. 5 Close door and measure from the door edge on the latch side to Z-bar minus 1/16” (Fig 7). Cut mouches réglable channel to width. Step 7: Cut and Install Adjustable Bug Sweep A.
  • Page 11: Instrucciones De Instalación

    WEB REV 1.25 Puerta De Malla EncloSure™ Instrucciones de instalación English ..................1 Français ..................6 Español ..................11 Lea todas las instrucciones antes de instalar el producto. Consulte las instrucciones de seguridad del fabricante cuando utilice cualquier herramienta. oldcastleapg.com/registration Para registrar su producto, visite:...
  • Page 12: Antes De Comenzar

    ADVERTENCIA: • La instalación incorrecta de este producto puede provocar lesiones personales. Utilice siempre gafas de seguridad al cortar, taladrar y montar el producto. • Una instalación incorrecta puede causar daños al producto o a la persona. AVISO: • NO intente montar el kit si faltan piezas o están dañadas. • NO devuelva el producto a la tienda. Para obtener asistencia o piezas de repuesto, llame al 1-877-265-2220. ANTES DE COMENZAR LISTA DE HERRAMIENTAS: 1. ¿Va a instalar la puerta a la IZQUIERDA o a la Ruban à mesurer DERECHA? Crayon Este kit se puede utilizar para instalaciones a Perceuse la izquierda o a la derecha.
  • Page 13 Step 1: Cut Left and Right Z-Bar to length Facing the house from the outside, measure the height of the top of the threshold (Fig 1A). Using that dimension, m and RIGHT Z-bars to the same length (Fig 1B). Keep thi Fig.
  • Page 14 Step 5: Install Side Expander/Piano Hinge Assembly Open the piano hinge and place it against right side Z-Bar “Hinge-guide Rail” (Fig 5A), down 1/8” to Step 5: Install Side Expander/Piano Hinge Assembly 3/16” from the Z-Bar header. This measurement will determine your final reveal (Fig 5B). Use #8x1 Open the piano hinge and place it against right side Z-Bar “Hinge-guide Rail”...
  • Page 15 Corte e instale el guardapolvo Step 7: Cut and Install Adjustable Bug Sweep Fig. 5 Close door and measure from the door edge on the latch side to Z-bar minus 1/16” (Fig 7). Cut channel to width. Step 7: Cut and Install Adjustable Bug Sweep A.
  • Page 16 Freestyle — Oldcastle ™ ® 400 Perimeter Center Terrace Suite 1000, Atlanta, GA 30346 FreestyleOutdoorProducts.com...

Table of Contents