Advertisement
Quick Links
ELECTRIC
PALLET TRUCK
JEFELPT15 JEFELPT20
JEFELPT20RC
SAVE THESE INSTRUCTIONS
Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or
subsequent owners. Apart from the notes contained herein the general safety provisions and rules for the prevention of accidents of
the legislator must be observed.
Warnings and notes that are attached on the appliance provide important notes for the safe operation.
www.jeffersontools.com
www.jeffersontools.com
www.jeffersontools.com
JEFFERSON ELECTRIC PALLET TRUCK
JEFELPT15 JEFELPT20 JEFELPT20RC
Advertisement
Summary of Contents for Jefferson JEFELPT15
- Page 1 JEFFERSON ELECTRIC PALLET TRUCK JEFELPT15 JEFELPT20 JEFELPT20RC ELECTRIC PALLET TRUCK JEFELPT15 JEFELPT20 JEFELPT20RC SAVE THESE INSTRUCTIONS Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners. Apart from the notes contained herein the general safety provisions and rules for the prevention of accidents of the legislator must be observed.
- Page 2 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC Specification Overall Displacement Diagram Model JEFELPT15 JEFELPT20/RC Characteristics Capacity kg (lbs) 1500kg (3300lb) 2000kg (4400lb) Load Centre mm (in) 600mm (23.6”) 600mm (23.6”) Overall fork width mm (in) 520/550/685 (20.5/21.6/27 ) 520/550/685 (20.5/21.6/27 )
- Page 3 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC Instructions. Instructions Cont. Steering Tiller The steering tiller in position “M” enables the truck to be driven. If travel, lift, or lower is commanded with the steering tiller in position “B” the truck will not respond and the display will read SRO ERR.
- Page 4 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC Instructions cont. Instructions cont. Smart Functions Up-right Drive Up-right drive allows the truck to be driven with the tiller in the fully vertical position. Use up-right drive to manoeuver the truck in tight quarters.
- Page 5 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC Handheld Intelligent Control (JEFELPT20RC) Operating Instructions Note: When using the truck there are some operations that, in spite of all the safety precautions, may cause it to overturn The optional intelligent control allows operation of some features of the truck using the handheld remote control.
- Page 6 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC LOADING INSTRUCTIONS AND PRECAUTIONS First Time Set Up Avoid loading material that may fall. You should bear in mind that the truck, even when it is equipped with a load backrest, Install the Tiller Handle.
- Page 7 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC Replace the drive wheel. Replace the Hydraulic Cylinder Cont. Disconnect the battery. 8. Reinstall the pistol shaft, pull up on the piston rod, and connect the shaft gland to the frame.
- Page 8 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC Wiring Diagram Hydraulic Schematic Components Troubleshooting Observed Symptom Troubleshooting Hydraulic Diagram Fault Code Troubleshooting. When the controller detects a failure, a fault code is displayed on the display in the format EER+nn, where nn is the fault code number from the table.
- Page 9 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC Troubleshooting Cont. Lithium-ion Battery user guide. Fault Code Troubleshooting Cont. Warning! Please read carefully and follow these terms and conditions for installing and using the battery. Improper installation or use may cause excessive heat and other hazardous conditions. Failure to follow these instructions may pose risk to life or damage to property.
- Page 10 ELECTRIC PALLET TRUCK USER MANUAL v.1.1 JEFELPT15 JEFELPT20 JEFELPT20RC Battery Charger Cont. Lithium-ion Battery user guide. 3. The battery protection class is IP20, when installed in the machine , it is IP50 . Please do not wash the battery directly with water.
- Page 11 EC Declaration of Conformity We, Jefferson Professional Tools & Equipment, as the authorised European representative of the manufacturer, declare that this equipment conforms to the requirements of the following: Machinery Directives 2006/42/EC Electromagnetic Compatibility 2014/30/EU EN ISO 12100:2010, EN ISO 3691-1:2015/A1:2020, EN 16307-1:2020, EN 1175:2020, EN 13059:2002+A1:2008,...
Need help?
Do you have a question about the JEFELPT15 and is the answer not in the manual?
Questions and answers