Speaker Terminals; Electrical Requirements; Operating The Unit; Clock Setting - Morphy Richards IB29107 Operating Instructions Manual

Electrical requirements

Check the voltage on the rating plate of your CD microsystem corresponds with
your house electricity supply which must be A.C. (alternating current).
If the socket outlets in your home are not suitable for the plug supplied with
this appliance the plug should be removed and the appropriate one fitted.
WARNING: The plug if severed from the mains lead must be destroyed as a
plug with a bared flexible cord is hazardous if engaged into a live socket
outlet.
Should the fuse in the 13 amp plug require changing a 3 amp BS1362 fuse
must be fitted.
Installing the speaker wire to the speaker terminals
1 Speakers connection
Extend the speaker wires and connect them to the speaker terminals.

Operating the unit

When you first plug in the unit it will be in standby mode.
1 Press the POWER button on the unit (or the STANDBY / ON button on the
remote control), press once to switch on and then again to switch off.
2 Pull the plug from the wall socket if you wish to disconnect the power supply to
the unit.

Clock setting

When you first plug in the unit it will be in standby mode.
1 Press the PROGRAM/CLK-ADJ button, the LCD display shows either 12H or
24H.
2 Press the SKIP/SEARCH (up or down) button to adjust 24-hour or 12-hour digit.
3 Press PROGRAM/CLK-ADJ button again, the LCD display shows the hour digit
flashing, then press the SKIP / SEARCH (up or down) to adjust the hour digit.
5