Table of Contents
Advertisement
Connect the speakers to main unit
1 Ensure the mains power is disconnected.
2 Connect the speaker wires between the main unit and the speakers.
Match the speaker wire to the appropriate terminal on the components:
(+) to (+) (colour), and (-) to (-) (black). (If the wires are reversed, the
sound will be distorted and will lack some tones.)
3 Hold down the terminal tab to insert each wire. Release the tab to lock
the wire into the terminal. Make sure the bare wire is fully inserted and
that the insulation reaches right up to the tab leaving no bare wire
visible.
• To avoid short-circuiting the speakers, make sure the the stripped end
of each speaker wire does not touch another terminal or another wire.
Connect to the wall socket
Plug the unit to a live wall outlet.
Aerial connection
Connect FM radio aerial plug to socket on back panel.
Backlight illumination in standby mode
Press any key (except
ON/STANDBY
control (when unit in standby mode) and the backlight for the display
illuminates and stays for a 10-seconds for you to check the information on
the display.
) on the control panel or the remote
Digital clock and timer settings
How to set correct time (in standby mode)
1 Press and hold
for more than 2 seconds.
CLK.ADJ
2 Press
to adjust the hours, press
SKIP/SEARCH
minutes.
3 Press
to confirm.
CLK.ADJ
4 The time set will remain until you switch off the unit by the power
switch.
Alarm clock/timer function
How to preset the timer function (during operation)
With the unit working, press and hold
following modes:
Timer on
Timer on hour
(power on with CD playback or tuned in radio station)
volume
Timer off
Timer off hour
Adjust the timer on/off hour and minute by means of
Choose timer on mode between CD/tuner by means of
buttons.
Then turn to stand-by. To turn off alarm hold down sleep/alarm on remote
control.
Sleep function
1 Press
on the remote control during CD playback or radio
SLEEP/ALARM
broadcasting.
2 Then press
to change display and sleep time in a
SLEEP/ALARM
sequence: 90
80
70
off.
When the sleep function is activated, the player goes to standby mode the
moment playback or broadcasting reaches the preset sleep time.
again to set the
CLK.ADJ
to toggle between the
CLK.ADJ
Timer on minute
Timer on mode
Timer on
Timer off minute.
buttons.
SKIP/SEARCH
SKIP/SEARCH
60
50
40
30
20
10
3
Advertisement
Table of Contents
