Room Calibration - Philips 7419 Series User Manual

level.
Custom Equalizer
 Settings > Display & Sound > Sound > EasyLink
2.0 > Custom Equalizer.
Adjust the frequency bands when the Sound style is set
to Custom. Press the Arrow/navigation keys to
adjust the AI Equalizer levels. This setting is only available
when the connected device is compatible with the TV.
Surround Sound
 Settings > Display & Sound > Sound > EasyLink
2.0 > Surround Sound.
Select a surround effect from the preset types.
• Upmix - Upmix to take full advantage of all speakers.
• Standard - Speaker output through the original
channels.
• Surround AI - Optimum surround effect using AI
analysis.
DRC
 Settings > Display & Sound > Sound > EasyLink
2.0 > DRC.
Select the preferred Dynamic Range Control (DRC).
• Auto - Dynamic range is automatically adjusted.
• On - Optimize the dynamic range.
• Off - Turn off dynamic range adjustment.
Height speakers
 Settings > Display & Sound > Sound > EasyLink
2.0 > Height speakers.
Select the preferred height speakers movement. This
setting is only available when the connected device is
compatible with the TV.
• Auto - Dynamic movement depending on content.
• On - Always elevated.
• Off - Flat position.
Select sound stage
 Settings > Display & Sound > Sound > EasyLink
2.0 > Sound stage.
Select a listening experience. This setting is only available
when the connected device is compatible with the TV.
• Auto - Dynamic setting changes depending on content.
• On - Immersive Sound Stage, good for watching
movies.
• Off - Crystal Sound Stage, good for listening to music
and dialog.
Reset all to default
 Settings > Display & Sound > Sound > EasyLink
2.0 > Reset all to default.
Reset all the EasyLink 2.0 sound settings back to the
original factory settings.
There are more settings options that may be available if
your HDMI sound system supports them:
Subwoofer level adjustment
Dolby Atmos adjustment
Height level adjustment
DTS Virtual X enable/disable
TRUE Volume enable/disable
Night mode enable/disable
Auto volume setting
Display enable/disable

Room Calibration

Room calibration
 Settings > Display & Sound > Sound > Room
calibration.
This calibration will allow the TV to determine the
acoustics in your room and provide optimized sound
quality through the TV speakers that best matches the
acoustics.
You need to pair your remote control with the TV before
starting the setup and make sure the TV Audio out
setting is TV speakers. For a more accurate result, please
keep the room quiet.
To start the room calibration:
1 - Hold your remote control at the listening position and
point it toward the TV during the tuning process.
2 - Select Calibrate now or Calibrate again to start the
calibration.
3 - A test sound will be played and measured through
your remote control. Hold your remote control and point
it toward the TV; this can take several seconds.
4 - Once your TV speakers are successfully calibrated,
select Test to listen to the sound before and after the TV
speakers are calibrated. Select Apply to accept the
setting or select Try again to redo the calibration.
5 - When room calibration setup is successful and
applied, the TV returns to the Settings menu. Now go
to  Settings > Display & Sound > Sound > Room
calibration and select Apply calibration to tune the
audio output from TV speakers.
33