Advertisement
S A F E T Y I N F O R M AT I O N
When using your hair straightener, basic safety
precautions should always be followed. Please read
these instructions carefully before using the product,
and keep them in a safe place for future reference.
I I
This straightener is professional standard, and
1
reaches very high temperatures. Always be careful
not to allow the plates to come into contact with
I I
the skin.
Do not leave the plates in contact with the hair for
2
more than a few seconds. The straightener reaches
very high temperatures, so there is no need to leave
the hair between the plates for longer than a few
seconds. This will avoid unnecessary damage to the
I I
hair cuticle.
I I
Use the appliance for its intended use only
3
To protect against the risk of electric shock, do not
4
CERAMIC COATED
RECESSED FINGER WELLS
STRAIGHTENING
PLATES
VARIABLE
SAFETY
SETTINGS
GUARDS
:
immerse the appliance in water or any other
I I
liquids.
It is recommended that this appliance should not be
5
I I
used by children.
I I
Always unplug your appliance when it is not in use.
6
Do not leave the straightener switched on while
7
I I
unattended.
Do not take this product into a bathroom, or use
8
I I
near water.
In the event of cable damage, do not attempt to
9
replace the mains cable – return to Morphy
I I
Richards.
After use, do not store until the product has cooled
1 0
I I
down.
Do not place the straightener on surfaces likely to
1 1
be damaged by the heat.
H OW TO U S E YO U R
S T R A I G H T E N E R
I I
1
Choose either setting I or II dependent on the
temperature you require. The temperature you
need will depend on the thickness of your hair
and the result you want to achieve. Setting 'I' is
the lowest, 'II' the highest. The red indicator
light will illuminate when you select the heat
I I
setting required.
INDICATOR
2
Once the straightener has reached a temperature
LIGHT
suitable for use, the light will begin to flash. This
HEAT
usually takes less than 1 minute.
!
Ensure your hair is thoroughly dry before you
begin styling – this will avoid damage to the
I I
hair.
3
Divide your hair into sections, brushing each
section thoroughly.
C L E A N I N G
It is normal to find build up of hair products on the
straightening plates. In order to avoid this you
should clean your straightener regularly. Always wait
for the plates to cool down thoroughly before
cleaning. Use a damp cloth to remove any build up.
If this fails to clean the plates, try a non abrasive
cleaning wipe e.g. CIF.
2 - Y E A R G U A R A N T E E
It is in your interest to retain the retailers receipt as
proof of purchase. Please quote the model number if
the product develops a fault. This number can be
found on the handle of the product.
All Morphy Richards products are individually tested
before leaving the factory. In the unlikely event of
This product is fitted with a 13A (BS1363) plug. A 3amp
fuse (BS1362) must be used. Check the voltage on the
rating plate of your appliance corresponds with your
house electricity supply which must be AC (Alternating
current). If the socket outlets in your home are not
suitable for the plug supplied with this appliance the
plug should be removed and an appropriate one fitted.
IMPORTANT: THE PLUG REMOVED FROM THE MAINS
LEAD, IF SEVERED MUST BE DESTROYED AS A PLUG
WITH BARED FLEXIBLE CORD IS HAZARDOUS IF
ENGAGED INTO A LIVE SOCKET OUTLET.
As a safety precaution and to prolong the life of your
appliance, do not wrap the mains lead around the
appliance as this will cause damage.
I I
:
4
:
I I
6
I I
I I
7
8
:
any appliance proving to be faulty within 28 days of
purchase it should be returned to the place of
purchase for it to be replaced.
If a fault develops after 28 days and within 24
months of original purchase, you should contact the
helpline number quoting the model number of the
product, or write to the address below. You will be
asked to return the product (in secure packaging) to
the address below along with a copy of proof of
:
purchase:
The After Sales Division,
Morphy Richards Ltd
Mexborough
South Yorkshire
England
S64 8AJ
W I R I N G
:
M A I N S L E A D
:
Clamp a section of the hair between the
straightening plates, as close to the roots as
possible. Gently slide the straightener down
your hair shaft to the ends. For more difficult
sections of hair, you may need to repeat this.
Avoid leaving your hair clamped inside the
straightener for more than a few seconds, as this
could cause unnecessary damage to the cuticle.
To create movement in the hair, use your wrist
to shape the ends either inwards our outwards
depending on the style you wish to achieve.
Repeat on all sections of the hair.
Clean your straightener regularly for best results.
Always do this when the straightener is switched
off and has cooled down.
Advertisement
