Morphy Richards IB20012 Instructions Manual page 4

For even cutting, allow the comb
attachment cutter to cut its way through the
hair. Do not force it quickly.
Comb hair frequently to remove trimmed
hair and to check for uneven strands.
To remove the comb attachment
1 Lower the comb attachment to the
lowest position.
2 Hold the unit in your hand with the
power switch facing the palm of your
hand.
3 With your thumb press upwards along
the centre of the
comb. The comb
attachment will
pop out (fig 4).
Charging
Before first use be
sure to fully charge
the clipper.
1 Plug the small end
of the power
adaptor into the
clipper body and
plug the adaptor
into the electrical
socket (fig 5).
2
3
Cordless use
BEC"
Be sure the unit is fully charged.
1
Should you notice a drop in power during
cordless use, simply plug the appliance in
and use it directly from the electrical socket.
BEC#
When finished clipping, turn the clipper off
by sliding the power switch down.
If the clipper has not been used for a
considerable length of time, recharge it
completely before use.
4
The clipper can also
be charged when
positioned in the
stand. Plug the
small end of the
adaptor into the
recharging stand
(fig 6) and
plug the adaptor into the electrical
socket.
The red power light will illuminate when
charging. When the power switch is
turned on, the light will go dark. A full
charge will take approximately 7 hours.
Unplug the adaptor from the clipper unit
and slide the power switch to turn the
power on.
BEC$