Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Digitus DA-70615
Summary of Contents for Digitus DA-70615
- Page 1 SAFETY PLUG (1x USB TYPE-C™, 1x USB A) Quick Installation Guide DA-70615...
-
Page 2: Package Content
1. Package Content 1x Main unit 1x User Manual 2. Energy Efficiency Input:180-250V~, 50/60Hz,Max 0.25A Output: 5.0V DC 2.8A, Max 14.0W For Type A Average active efficiency: 82.5 % Efficiency at low load (10 %): 78.0 % For Type C ... - Page 3 (ATTENTION: the cross-sectional area of wire connect power is at least 1.5mm^2 not exceed 2.5mm^2） 3. To fix the base by the screw or claw as Diagram B or Diagram C, then put the frame onto the base. 3.1 Cavity wall/ Dry construction...
- Page 4 3.2 Solid wall (brick)
-
Page 5: Explanation Of Symbols
4. Explanation of symbols For indoor use only SMPS (switch mode power supply unit) SMPS incorporating a Short-circuit-proof safety isolating transformer (inherently or non-inherently) Symbol for class II Protective earth Protective earth... - Page 6 5. Warning The following safety instructions must be observed before use: Operate the device indoors only. Avoid the influence of moisture, dust, sunlight or other sources of heat. The socket outlet is part of the building installation. The relevant national standards and directives must be observed during planning and installation.
- Page 7 Installation may only be carried out in commercially available flush-mounted boxes (appliance boxes) in accordance with DIN 49073-1, with a minimum depth of 40 Observe the permissible cables and cable cross-sections when connecting to the device terminals. Mandatory information in accordance with the appliance safety standard: Note ! Installation only by persons with relevant electrical...
- Page 8 be personally liable for personal injury and damage to property. Contact an electrician. Specialist knowledge required for installation: The following specialist knowledge in particular is required for installation: the application of the 5 safety rules: Disconnect Secure against restarting Ensure that there is no voltage Earth and short-circuit cover or isolate neighboring live parts selection of suitable tools, measuring equipment and, if...
- Page 9 shutdown conditions. checking the electrical system after installation. observing the IP protection classes installation exclusively with suitable electrical installation material checking and observing the respective specifications for the type of supply network (TN system, TT system or IT system) and the resulting connection conditions (zeroing, protective earthing, or any additional measures required, etc.).
- Page 10 do not use wet cloths or sponges to clean the appliance. Declaration of Confirmity Hereby ASSMANN Electronic GmbH declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below mentioned manufacturer address.
Need help?
Do you have a question about the DA-70615 and is the answer not in the manual?
Questions and answers