Download Print this page
Magnadyne M99XXSDKIT Installation Manual
Magnadyne M99XXSDKIT Installation Manual

Magnadyne M99XXSDKIT Installation Manual

Din radio mounting adapter for replacement of m99xx series radios with a single din radio

Advertisement

Quick Links

Installation Manual
DIN Radio Mounting Adapter for
Replacement of M99XX series radios
with a single DIN radio
Radio and radio components not included.
83855 98776
7
3
M99XXSDKIT

Advertisement

loading
Need help?

Need help?

Do you have a question about the M99XXSDKIT and is the answer not in the manual?

Questions and answers

Summary of Contents for Magnadyne M99XXSDKIT

  • Page 1 Installation Manual DIN Radio Mounting Adapter for Replacement of M99XX series radios with a single DIN radio Radio and radio components not included. 83855 98776 M99XXSDKIT...
  • Page 2: Installation Kit

    Installation of M99XXSDKIT Installation Kit *Radio and radio components are not included. Tools you’ll need Wire cutters, flat blade, strippers, screw driver, crimp tool STEP 1 Insert the DIN tools into the two holes on each side of the radio.
  • Page 3 Installation of M99XXSDKIT (cont.) STEP 4 Unplug the harness and AV cables from the back of the radio. (Installer’s Note: Be careful not to let the cables fall back inside the dash.) STEP 5 Using a small screwdriver or similar tool, bend the mounting tabs that hold the radio collar in place up and out of the way.
  • Page 4 Installation of M99XXSDKIT (cont.) STEP 8 Cut and strip the old radio’s power wires starting with yellow constant hot, then black chassis ground, then red ignition. (Installer’s Note: Once the power wires are finished, the speaker wires can be replaced in any order.
  • Page 5 Installation of M99XXSDKIT (cont.) STEP 12 Prepare the new radio collar by sliding the black trim around it. (Installer’s Note: Large area is the top of the bracket.) STEP 13 Installer’s Note: Black sharpie can be used to blacken the edge of the collar for aesthetics.
  • Page 6: Speaker Connection

    Installation of M99XXSDKIT STEP 16 Plug the harness and AV cables into the back of the new radio. STEP 17 Insert the radio into the dash. (Installer’s Note: After checking all connections re-connect the vehicle’s battery.) Speaker Connection Right Right...
  • Page 7 Speaker Connection Right Right Reference to Radios: Front Speaker Rear Speaker M9900CDS, M9900DVDS, M1-CD Purple Wire: Rear Right Speaker (+) Purple/Black Wire: Rear Right Speaker (-) Gray/Black Wire: Front Right Speaker (-) Gray Wire: Front Right Speaker (+) Green Wire: Rear Left Speaker (+) Green/Black Wire: Rear Left Speaker (-) White/Black Wire: Front Left Speaker (-) White Wire: Front Left Speaker (+)
  • Page 8 © Copyright 2025 Magnadyne Corporation M99XXSDKIT-INS Rev. B 3-03-25...