Advertisement
19
other things you should know
Connecting another speaker, such as a sub woofer
A sub woofer is the name for a speaker which improves the low
frequency (bass sounds) of music which you are playing. This gives a
richer and deeper sound to your music. Use a standard RCA cable from
the sub woofer to the SUB WOOFER OUTPUT socket on the right hand
side of the unit. Passive sub woofers which do not have their own power
source will not work with this System.
Connecting headphones
There is a headphone socket on the right hand side of the unit.
Wall fi xing
The System is designed to be either free-standing on a table or shelf, or
fi xed to a wall. The templates supplied with the System show the spacings
for the wall fi xing screws (supplied). Don't forget to use a spirit level when
using the templates, to make sure you fi t the System perfectly horizontal.
Specifi cations
Power supply:
AC 230V 50/60 Hz
Power consumption:
32W
Remote control unit:
3V (2 AAA batteries
required, supplied with the unit)
System's memory:
3V (2 AA batteries required, not supplied)
Speaker:
120mm x 2 woofer, 38mm x 2 tweeter
Speaker capacity loading:
4 Ohm
Amplifi er maximum power:
10W
FM band range:
87.5MHz to 108MHz
MW band range:
522KHz to 1620KHz
Supporting MP3 format:
MPEG 1/2/2.5 Layer 2/3 (ISO/IEC
111723, ISO/IEC 13818-3.2)
Supporting bitrate for MP3:
8 - 384kbps (included variable bitrates)
Supporting sampling rate freq: 32/44.1/48 kHz, 16/22.05/24 kHz and
8/11.025/12 kHz
CD-R format:
ISO9660, JoliET and Romeo
Safety advice
Please don't use the System in a damp environment such as a bathroom.
Please don't expose the System to dripping or splashing liquids.
Please switch off and withdraw the mains plug before making or
changing connections.
Please consult the retailer where you purchased the System, if you are in
doubt about the installation or operation.
Please don't remove any fi xed covers as this may expose dangerous
voltages.
Please don't continue to use the System if you think it may not be
working normally, or if it is damaged in any way. Switch off, remove the
mains plug and consult your dealer.
mr_Hi-Fi guide TO PRINT.indd 4-5
mr_Hi-Fi guide TO PRINT.indd 20-21
TS IB-778-PM3Ui-001.indd 10-11
TS IB-778-PM3Ui-001.indd 10-11
Troubleshooting
MP3 fi les can be saved at different compression levels. 128 Mbs
(megabits per second) is the standard level. Although saving tracks with
more compression will make the fi les smaller, it may case problems when
playing. Always check that your fi les are saved at 128 Mbs or higher.
The System has an automatic electronic cut out, which is designed to
avoid damage to the System. The effect of this is that the System will
'freeze' and stop working. If this happens, simply turn the unit off, so that
the blue lights go out in the display, and turn it on again.
ESP
The Electronic Shock Protection function prevents the CD 'skipping' if the
System is accidentally knocked during play. When a CD is fi rst played,
ESP will fl ash for several seconds indicating that the anti-skip memory is
being fi lled up. When ESP stops fl ashing, the memory is full. This feature
works in the background automatically and will not affect your normal use
of the System.
Electrostatic discharge
In case of malfunction due to electrostatic discharge just reset the micro
system (reconnection of power may be required) to resume normal
operation.
Guarantee
Morphy Richards products are manufactured to internationally accepted
quality standards. In addition to your statutory rights, Morphy Richards
guarantee your product to be free from manufacturing and component
defects for a period of TWO YEARS from date of purchase.
If your product proves to be defective within 28 days of purchase, your
Morphy Richards dealer from whom the product was purchased will be
pleased to replace it free of charge.
Should your product develop a defect within the guarantee period but
after the replacement period, please return the product to the following
address, together with the proof of purchase, brief details of the
symptoms and your own name and address.
After Sales Division
Morphy Richards Limited
Mexborough
South Yorkshire
S64 8AJ
Your post offi ce will provide a certifi cate of posting. The product will be
repaired and returned to you promptly.
f
put two AAA batteries
in the remote control
You will fi nd two batteries in the box
your system arrived in.
how you can get the
best from this guide
Most functions are controlled using either the buttons on
the front of the main Hi-Fi unit or the remote control.
The Guide is designed so that you can decide, at any
time, whether you want to use the buttons on the front
of the Hi-Fi unit or the remote control.
Morphy Richards Hi-Fi- System
4
plug in and
Remove the protective plastic cover
from the three pin mains plug. Insert it
switch on
into a household socket.
The unit is now in 'Standby'. To turn it
'On' press the power button, the blue
display will show.
The System is designed to be left in
standby when you are not using it.
This saves electricity, but ensures that it
e
can be turned 'On' at any time from the
remote control.
The action you have to
On the right of the page are two
perform will be written on
columns, showing the buttons
the left of the page, like this.
which perform the action on
both the front of the Hi-Fi unit
or the remote control.
4/11/05 10:28:10 am
4/11/05 10:28:41 am
11/12/2005 16:27:09
11/12/2005 16:27:09
Hide quick links:
Advertisement
