Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Blaze Audio Ci2 Series
Summary of Contents for Blaze Audio Ci2 Series
- Page 1 Loudspeaker Installation Manual Ci2 BLK/Ci2 WHT...
-
Page 2: Table Of Contents
Content Introduction Getting started Installation Mounting the cabinets together Cables Operation Specifications... -
Page 3: Introduction
Introduction Congratulations on your new Ci loudspeaker system from Blaze Audio. The Ci series is a feature packed range of loudspeakers designed for use in a large variety of applications. Emphasis is placed on discreet modern design, ease of installation, wide and uniform coverage and excellent sound quality without the use of electronic signal processing. -
Page 4: Getting Started
Note: It is important that you run the speaker cables through the port BEFORE installing your new Blaze Audio speakers! The speakers are equipped with discreet cable terminals placed on the front baffle behind the front cover – and it is not possible to run the cables to the terminals once the speakers have been installed. -
Page 5: Installation
Installation The Ci series can be mounted either in corners or on walls and ceilings with the integrated mounting points. They can also be coupled together to extend coverage. The Ci2 is very light, but please make sure that the wall or ceiling is solid and can support the weight of the speaker before installing. -
Page 6: Mounting The Cabinets Together
When you have installed the speaker to the wall or ceiling, then connect the speaker cable to the terminal and reinstall the front cover. Connect the red (+) speaker cable to the red cable terminal and the black (-) speaker cable to the black speaker terminal. Mounting the cabinets together Our Ci series speakers are designed with an emphasis on uniform and wide controlled dispersion. -
Page 7: Cables
Cables Speaker cables present the amplifier with different loads. Cables with high capacitance, high inductance and high impedance have a strong negative influence on sound quality as well as amplifier reliability. In order to get the most out of the speaker system, avoid using thin speaker cables. As a rule of thumb, 2 mm (14 AWG) cable can be used for lengths up to 20 meters. - Page 8 As with all quality loudspeakers, your Ci2 has to play for approximately 30 hours before performing to specification. Warranty. For warranty information, please refer to your local Blaze Audio distributor or dealer, or contact us directly. Service. Woofers can be easily replaced by unscrewing them from the baffle using a Hexagon H3 bit. The tweeter is clicked into the horn section of the baffle from the rear of the baffle.
-
Page 9: Specifications
White (RAL9010) Black (RAL9005) Contents of the manual are subject to change without notice. Blaze Audio does not accept any liability for loss or damage caused or alleged to be caused directly or indirectly by these instructions. Blaze Audio HQ, Pascal A/S, Ellekaer 6, DK-2730 Herlev, Denmark.
Need help?
Do you have a question about the Ci2 Series and is the answer not in the manual?
Questions and answers