Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for PowerPac PPIC888
Summary of Contents for PowerPac PPIC888
- Page 1 INDUCTION COOKER Model: PPIC888 1 9 0 4 9 4 - 2 4...
-
Page 2: Parts & Description
PARTS & DESCRIPTION Air entry Crystal Plate Control panel Air vent Usable Pots/Pans Only Stainless steel flat-based pots & pans with a diameter between 12 cm to 26 cm are usable. Non-usable Pots/Pans Material : glass, heat-resistant glass, ceramic, copper, aluminium. Pots &... - Page 3 FEATURES The Induction cooker consists of coils of copper wire beneath a Crystal Plate made of ceramic. When electricity runs through the copper wire, if a pot or pan containing a magnetic material such as stainless steel is placed on top of the Crystal Plate, it “induces” (or causes) an electric current to flow in the pot or pan.
- Page 4 WARNINGS ATTENTION : Read this booklet carefully it contains important instructions for a safe installation, use and maintenance. Important instructions to be kept for future reference. The following basic precautions should always be followed when using electrical appliances: Read all instructions before using the appliance. The Appliance This appliance must be used only for the purpose it was expressly designed;...
- Page 5 Avoid placing the power cable (and extension cable, if used) on abrasive or sharp surfaces or in positions where it can be damaged easily. Avoid placing heavy objects on the cable. The cable must NOT be placed under carpets, or covered with throw rugs, runners or similar. Arrange the cable away from the high traffic area, and where it will NOT be tripped over.
- Page 6 • remove the utensil during heating. Wait until heating has completed, press the ON/OFF button and then remove the utensil carefully; • touch the Crystal Plate of the appliance except the Control Panel buttons or the Power Knob when in operation or just after switching it off as it will still be very hot and may cause scalding Always wear protective, insulated oven gloves when in contact with the utensil.
-
Page 7: Using Your Appliance
USING YOUR APPLIANCE Soup Steam Water Slow Fire Stir Fire Hot Pot Cook Gruel Elec/Volt Timer/Preset Down Function On/Off REMINDER: Press the ON/OFF button after you have finished cooking. The appliance will stop heating immediately and the screen will display “_____”. DO NOT switch the appliance off by pressing the wall switch. - Page 8 CLEANING Disconnect the plug and wait until the unit has cooled down completely. Always clean cooking appliances such as pots & pans soon after use. This will prevent food from sticking to the appliance and reduce the possibility of bacterial growth. It will also reduce the likelihood of the utensils being stained or discoloured.
-
Page 9: Problem Solving
Wait for a new minutes before circuited because of empty pot or pan switching the appliance on No pot/pan on the plate or Put suitable pot/pan on the plate non-usable pot/pan on the plate SPECIFICATION MODEL VOLTAGE WATTS(W) PPIC888 220-240V ~ 50/60Hz 2000W... -
Page 10: Warranty
However, if the customer still requests that the defective appliance be repaired, PowerPac Electrical Pte Ltd may, at its discretion, repair the appliance but impose a labour charge, as well as the costs of the replacement parts, to be borne solely by the customer.
Need help?
Do you have a question about the PPIC888 and is the answer not in the manual?
Questions and answers
how to set timer on water mode for 10 minutes than stop?
To set the timer for 10 minutes on the PowerPac PPIC888 in water mode:
1. Select the "Water" function using the Function button.
2. Use the "Up" or "Down" timer buttons to set the time to 10 minutes.
3. Press the ON/OFF button to start cooking.
The appliance will begin heating in water mode for 10 minutes.
This answer is automatically generated