VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.faure.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
Page 3
This appliance may be used in, offices, hotel guest rooms, bed • & breakfast guest rooms, farm guest houses and other similar accommodation where such use does not exceed (average) domestic usage levels. To avoid contamination of food respect the following •...
SAFETY INSTRUCTIONS INSTALLATION • The mains cable must stay below the level of the mains plug. WARNING! Only a qualified person • Connect the mains plug to the mains socket must install this appliance. only at the end of the installation. Make sure that there is access to the mains plug after the •...
• Concerning the lamp(s) inside this product and • The following spare parts will be available for 7 spare part lamps sold separately: These lamps years after the model has been discontinued: are intended to withstand extreme physical thermostats, temperature sensors, printed conditions in household appliances, such as circuit boards, light sources, door handles, door temperature, vibration, humidity, or are intended...
Page 6
DIMENSIONS necessary to allow door opening to the minimum angle permitting removal of all internal equipment Overall dimensions ¹ LOCATION This appliance is not intended to be used as a built- in appliance. In case of different installation from freestanding respecting space required in use dimensions, the appliance will function correctly but energy consumption might increase slightly.
CAUTION! If you install the appliance next to a wall, refer to the installation instructions to understand the minimum distance between the wall and the side of the appliance where door hinges are to provide enough space to open the door when the internal equipment is removed (e.g.
Page 8
12. Fit the door on the lower hinge making sure the place. hinge pin enters the door bottom hole. 13. Install the upper hinge on the opposite side of the appliance. Fit the upper hinge pin into the door upper hole. Tighten the screws. 2.
bearing. is no gap between it and cavity, then fix the screw. 5. Fit the freezer compartment door and close them. 7. Take out hole covers from a bag and put them 6. Fix the installation button to the door lower in the holes left after the door hinge.
FREEZING FRESH FOOD To put the shelf back in: 1. Place the shelf flat on the door. The freezer compartment is suitable for freezing 2. Push two sides of the shelf downwards at the fresh food and storing frozen and deep-frozen food same time so that the shelf fits both fasteners.
• Fridge: Do not set too high temperature to save • Do not re-freeze defrosted food. If the food has energy unless it is required by the defrosted, cook it, cool it down and then freeze characteristics of the food. •...
2. Remove any stored food, wrap it in several CAUTION! The accessories and parts layers of newspaper and put it in a cool place. of the appliance are not suitable for washing in a dishwasher. CAUTION! A temperature rise of the frozen food packs during defrosting may shorten their safe PERIODIC CLEANING...
Page 14
Problem Possible cause Solution There is no voltage in the Connect a different electrical mains socket. appliance to the mains socket. Contact a qualified electrician. The appliance is noisy. The appliance is not supported Check if the appliance stands properly. stable.
Problem Possible cause Solution There is too much condensed Door was opened too fre- Open the door only when nec- water on the rear wall of the re- quently. essary. frigerator. Door was not closed com- Make sure the door is closed pletely.
3. Replace the bulb with the one that has identical CLOSING THE DOOR characteristics and is specifically designed for 1. Clean the door gaskets. household appliances. 2. If necessary, adjust the door. Refer to 4. Reassemble the lamp cover. "Installation" chapter. 5.
INFORMATION FOR TEST INSTITUTES Installation and preparation of the appliance for any as stated in this User Manual at Chapter 3. Please EcoDesign verification shall be compliant with EN contact the manufacturer for any other further 62552. Ventilation requirements, recess information, including loading plans.
Need help?
Do you have a question about the FRG10880WA and is the answer not in the manual?
Questions and answers