Summary of Contents for Vertilon PhotoniQ IQSP480M
- Page 1 OEM Manual PhotoniQ Series IQSP480M / IQSP580M 32 Channel OEM Data Acquisition Systems Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com...
-
Page 3: Copyright Information
Vertilon reserves the right to change this product without prior notice. No responsibility is assumed by Vertilon for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under the patent and proprietary information rights of Vertilon Corporation. - Page 4 IQSP480M/580M 32 Channel OEM Data Acquisition Systems - 2 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com...
-
Page 5: Table Of Contents
Figure 3: Printed Circuit Board Mechanical Assembly ................13 List of Tables Table 1: Ordering Information ........................5 Table 2: Daughtercard Trigger Interface Voltage Levels................10 Table 3: Daughtercard Connector......................11 - 3 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com... -
Page 6: General Safety Precautions
To avoid electric shock or damage to the product, do not operate in wet or damp conditions. Do Not Operate in Explosive Atmosphere To avoid injury or fire hazard, do not operate in an explosive atmosphere. - 4 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com... -
Page 7: Product Overview
OEM Manual Product Overview The PhotoniQ Models IQSP480M / IQSP580M are the OEM versions of Vertilon’s IQSP480 / IQSP580 thirty-two channel PMT data acquisition systems. Implemented on a single printed circuit board without an enclosure, the IQSP480M and IQSP580M are easily integrated with other electronics to build more sophisticated electro-optical instruments. Other than for mechanical interface differences, these units are identical in performance to their non-OEM counterparts. -
Page 8: Hardware
8. USB 2.0 Cable 4. Optional Sensor Interface Board Cable 9. System Software CD-ROM (not shown) 5. Optional High Voltage Bias Modules (2) - 6 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com... -
Page 9: Accessories
• Sensor interface board cable, PCB mount, 30 cm, 60 cm, and 90 cm (SBC030P, SBC060P, SBC090P) • Sensor interface board with 32 SMA coax connectors (SIB132M) • Thirty-two (32) channel Front End Module (FEM480M / FEM580M) - 7 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com... -
Page 10: Electrical Interface
The photo below shows the sensor, trigger, power, and interface connectors available to the user on the PhotoniQ main board. Figure 2: Main Board - 8 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com... - Page 11 3. Ground is located on pin 8. Additionally logic signals indicating the state (on or off) of high voltage bias supplies #1 and #2 are located on pins 5 and 6, respectively. - 9 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010...
-
Page 12: Daughtercard Interface
The sections below describe the standard signal set available on the daughtercard connector. The table on the following page summarizes the standard signal set. OEMs wishing to utilize the more advanced features on this interface should contact Vertilon. Power Raw, unfiltered, +5V power is present on the daughtercard connector. -
Page 13: Daughtercard Connector
RSVD RSVD RSVD TRIG IN TRIG OUT RSVD RSVD RSVD GP OUT RSVD RSVD +1.2V +1.2V +1.2V +1.2V Table 3: Daughtercard Connector - 11 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com... -
Page 14: Sensor Interface Board Connector
(32) low noise, parallel coaxial connections are provided through this small form factor connector (Samtec P/N QTE-020-01-L-D-A). The pinout for this connector is given in the PhotoniQ User Manual. - 12 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010... -
Page 15: Mechanical Information
Item #6: SIB cable mounting point, #4-40 threaded inserts (2 pl.). All dimensions in inches. Figure 3: Printed Circuit Board Mechanical Assembly - 13 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com... - Page 16 IQSP480M/580M 32 Channel OEM Data Acquisition Systems - 14 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com...
- Page 17 OEM Manual - 15 - Vertilon Corporation, 66 Tadmuck Road, Westford, MA 01886 Tel: (978) 692-7070 Fax: (978) 692-7010 www.vertilon.com...
- Page 18 Vertilon reserves the right to change this product without prior notice. No responsibility is assumed by Vertilon for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under the patent and proprietary information rights of Vertilon Corporation.
Need help?
Do you have a question about the PhotoniQ IQSP480M and is the answer not in the manual?
Questions and answers