BMW SERIE 3 CONVERTIBLE 2003 Owner's Manual page 18

Table of Contents

Advertisement

Indicator and warning lamps
18
Technology that monitors itself
Indicator and warning lamps that are
identified by
are tested for proper
functioning whenever the ignition key is
turned. They each light up once for dif-
ferent periods of time.
If a fault should occur in one of these
systems, the corresponding lamp does
not go out after the engine is started, or
it lights up while the vehicle is moving.
You will see how to react in the follow-
ing section.
Red: stop immediately
Battery charge current
The battery is no longer being
charged. Indicates a defective
alternator drive belt or a problem with
the alternator's charge circuit. Please
contact the nearest BMW center.
If the drive belt is defective, stop
and switch off the engine immedi-
ately to prevent overheating and seri-
ous engine damage. If the drive belt is
defective, increased steering effort is
also
required.<
Engine oil pressure
Stop the vehicle immediately
and switch off the engine.
Check the engine oil level; top off as
required. If the oil level is correct:
please contact the nearest BMW cen-
ter.
Do not continue driving, as the
engine could sustain serious dam-
age from inadequate
lubrication.<
Tire Pressure Monitor (TPM)/Flat
Tire Monitor
In addition, an acoustic signal is
sounded: a tire failure has occurred.
Reduce vehicle speed immediately and
stop the vehicle. Avoid hard brake
applications. As you steer the vehicle,
use caution to avoid overcorrecting.
For additional information: refer to
pages 92,
93
Brake warning lamp
If the lamp comes on when the
parking brake is not engaged:
check the brake fluid level. Before driv-
ing further, be sure to comply with the
instructions on pages
124
Parking brake warning lamp for
Canadian models.
Red: an important reminder
Brake warning lamp
Comes on when the parking
brake is engaged – an additional
acoustic signal sounds when you start
off.
For additional information: refer to
page
72
Parking brake warning lamp for
Canadian models.
Lock backrest/Fasten safety
belts
Comes on together with an
acoustic signal until the safety belts are
fastened. Flashes if the backrest is not
locked.
For additional information on safety
belts: refer to page
Airbags
Please have the system
inspected at your BMW center.
For additional information: refer to
page
61
and 139.
Online Edition for Part-No. 01 41 0 156 806 - © 09/02 BMW AG
56

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

325ci330ci

Table of Contents