Bulbs - BMW F 800 GS Rider's Manual

8
104
Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.
z
with centre stand
If the motorcycle is raised
too far the centre stand will
lift clear of the ground and the
motorcycle could topple to one
side.
When raising the motorcycle,
make sure that the centre stand
remains on the ground. If ne-
cessary, adjust the height of the
front-wheel stand.
Make sure the motorcycle is
standing firmly.

Bulbs

General instructions
A warning appears in the multi-
function display if a bulb is de-
fective.
A defective bulb places
your safety at risk because
it is easier for other users to
oversee the motorcycle.
Replace defective bulbs as
OE
soon as possible; always carry a
complete set of spare bulbs if
possible.
The bulb is pressurised and
can cause injury if dam-
aged.
Wear protective goggles and
gloves when changing bulbs.
The types of bulb fitted to
your motorcycle are listed
in the section entitled "Technical
data".
Replacing low-beam and
high-beam headlight bulb
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove cover 1 for the high-
beam headlight or cover 2 for
the low-beam headlight.