Red Arrow HLBDS Installation Instructions

Safety Warning
•
The installation should be carried out
by a qualified electrician in compliance
with the current edition of the IEE
Wiring Regulations.
•
Prior to installation, carry out the
necessary risk assessment considering
the people who could be at risk,
the level of risk and the precautions
required to control the risk
•
Ensure that the circuit supply is
isolated either by the circuit supply
fuse being removed or the applicable
Specification
Box Contents -
1 x Daylight Sensor
Dimensions: L: 75 x W:33 x D:25mm
Material: Polycarbonate
IP Rating:
IP20
Working
-35°C - 70°C
Temperature:
Guarantee: 5 Years
5
IP20
YRS
GUARANTEE
Installation Instructions
Note: Ensure all Electricity supply is switched off completely before installing or servicing this product.
Wiring
1. HLBDS + 1-10V Control Gear, with no motion sensors.
2. HLBDS + Microwave Sensor + 1-10V Control Gear.
3. HLBDS + 1-10V Microwave Sensor + 1-10V Control Gear.
Please be noted that whether or not the lamp can be switched off depends on the control gear. HLBDS has the lowest voltage output 1.1-1.2v, if the control gear
can switch the lamp off at this low voltage, the lamp can be switched off.
INSTALLATION INSTRUCTIONS
1-10V Control Daylight Sensor
Product Codes: HLBDS
•
•
•
1-10V
Red Arrow Electrical Ltd
Cortonwood Drive, Brampton,
Barnsley, S73 0UF
circuit breaker being turned off before
installation or any maintenance.
Check the total load on the circuit
ensuring the luminaire does not exceed
the rating of the circuit cable, fuse or
circuit breaker.
Long-term use and voltage fluctuations
can reduce the life span of the fitting.
If the fitting incorporates control gear,
ensure careful sizing to avoid instances
of nuisance tripping of the protective
device used in the installation.
T: 0800 195 0006
sales@redarrowelectrical.co.uk
•
Follow the provided installation
instructions, using the fixings supplied
or recommended.
•
Keep out of reach of children.
L75mm
redarrowelectrical.co.uk