FLAJZAR HL346P Quick Start Manual

Wireless LED Fisherman's Headlamp
The headlamp is not just designed for normal lighting, thanks to the integrated receiver it can be switched on automatically after a
bite. Up to eight devices can be stored in the headlamp memory at one time. The headlamp not only lights-up after the fish bite based
on the signal sent from the bite alarm, but also based on the alarm signal sent from the FISHTRON ALF3 fishing alarm.
It's a rechargeable LED headlamp with a powerful battery, two white and two red luminous fluxes, zoom (luminous flux widening and
narrowing) as well as the option of turning the Sensor on with the Hand Movement function.
The headlamp has several essential advantages - long battery life, low weight and fast charging. The battery status is indicated by
the blue LEDs at the front of the headlamp.
The headlamp has a quality strap to secure it to your head. It has sufficient IP for the use of the headlamp in nature.
Technical data
Power supply: built-in 3.7V/1800mAh LiPo battery
•
Charging: via a USB-C cable
•
Charging time: 3.5 hours
•
Number of white LEDs: 1
•
• Optical zoom - possibility to narrow or widen the light cone
Number of red LEDs: 4
•
Battery status indication: 5 blue LEDs on the front of the headlamp
•
Luminous flux: up to 260 lm
•
The headlamp can be paired with the FISHTRON NEON TX3, FISHTRON CatFish TX3, FISHTRON Q9-RGB TX, FISHTRON
•
e3TX bite alarms and the FISHTRON ALF3 fishing alarms
Number of memory positions (maximum number of devices learned at one time): 8
•
Range: up to 150 metres
•
IP 66 - fully dustproof and protection against high pressure
•
water jets
Weight: 118.2g
•
Size: 70 x 46 x 52mm
•
Operating temperature: -10° to +50°C
•
Using the headlamp
On button – it's possible to switch between 4 light modes by pressing
the button within 3 seconds
1 st white LED 100% - lasting up to 3 hours
-
2 nd white led 50% - lasting up to 6 hours
-
3 rd red LED 100% - lasting up to 11 hours
-
th
4 red LED 50% - lasting up to 19 hours
-
The headlamp contains the last light mode memory function. If we turn the headlamp on with the ON-OFF button, the headlamp
remembers the selected mode after 3 seconds of light and is turned off by pressing the ON-OFF button again (we don't have to switch
between the remaining light modes). However, if you want to switch the modes, press the ON-OFF button repeatedly within 3 seconds.
SENSOR button – when pressed, the Hand Movement Sensor is activated. Contactless switching on and off of the headlamp is
controlled by hand movement within 25 cm from the headlamp.
Switching the receiver on and off
To switch on the receiver, hold the button on the side of the headlamp for approximately 1.5 seconds until the green LED on
•
the front of the headlamp lights-up. The receiver is now on. Switching off the receiver is done in the same way, i.e., by holding
the button for about 1.5 seconds until the green LED on the front of the headlamp goes out.
Always switch the receiver off when the fishing is over, when you don't need it, this will extend the headlamp's battery life.
•
Saving the transmitter code in the headlamp memory (pairing)
(HL346P)
with automatic lighting after bite
Thank you for purchasing the HL346P Wireless LED Fisherman's Headlamp.
We hope that it's to your satisfaction.
.
zapnutí – On/off button;
senzor – SENSOR button;
přijímač – Receiver button