Sealey CCS01.V2 Quick Installation Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
Read these instructions before assembling and/or using the product.

Perform a risk assessment before assembling the product.

NOTE: This is a temporary structure and is not recommended as a permanent structure.
This product requires 2-3 people to assemble.

This temporary shelter is intended to off er protection from damages caused by the sun, light rain, light snow, tree sap, bird and

animal excrements.
Have an overview of all parts before attempting installation. Make sure all components are available.

Always wear safety glasses when assembling this product.

Wear gloves when working with tubing to prevent cuts or abrasions.

WARNING! Keep away from electrical wires!

WARNING! Anchors must be used with alI shelters. Covers should NOT be installed untiI it has been properly anchored to the ground.

NOTE: Proper anchoring and keeping cover tight and free of snow and debris, is the responsibility of the consumer. Damages caused
by improper anchoring are not covered under warranty.
WARNING! Keep all fl ame and heat sources away from the shelter fabric. The fabric will burn if left in continuous contact with a fl ame

source.
WARNING! In order to reduce risk of burning and avoid damage, DO NOT:

- cook, smoke, refuel or use any open fl ame devices in or around the shelter.
- store fl ammable liquids (gasoline, kerosene, propane, etc.) in the shelter.
- operate gas powered equipment in or around the shelter.
DO NOT install the shelter near overhead utility lines, branches etc.

DO NOT install the shelter near roofs or other structures that may shed snow, ice or excessive run-off onto your shelter.

DO NOT use this product in environments for which it is not intended (i.e. extreme cold, high winds, extreme heat, heavy rainfall, etc)

DO NOT use hard-edged tools or instruments, such as rakes or shovels, to remove snow. These can cause punctures to the cover.

DO NOT use it to shield goods from high winds, heavy snow or ice storms. Only use it for its intended purpose.

DO NOT use open fl ames or cooking or heating devices inside or in close proximity to the product, including all types of stoves, gas

heaters, gas lanterns, citronella torches, mosquito coils, etc.
▲ DANGER! DO NOT start the engine of any vehicle or machine inside a closed shelter. Ensure that there is adequate ventilation for
starting engines and for any work with paints, cleaners,
etc.
2. INTRODUCTION
Durable, water-resistant polyester cover suitable for year
round protection. Mesh vent windows with covers that
can be unfolded and secured with a hook and loop pad,
or rolled up and tied in place to ventilate the car shelter.
Hook and loop sections means the cover is easy to attach
to the frame. Built in locking mechanism can be locked
with a padlock to keep the shelter secure. Manufactured
with painted steel frame and a hinged opening for easy-
access. Shelter can be secured to the ground via a
central anchor point (ground fixings included).
3. SPECIFICATION
Model No: ...................................................... CCS01.V2
Overall Size (W x D x H): ..........................2.7 x 5.5 x 2m
Material: ........................................600D with PU coating
© Jack Sealey Limited
VEHICLE STORAGE SHELTER
CCS01.V2
MODEL NO:
Fig.1
Original Language Version CCS01.V2 Issue 1 04/08/23